User manual KYOCERA KD235GX-LPB

[. . . ] KKM-SM/2 KKM-SM-0542 1/2 MOUNTING GUIDE FOR THE KD225GX-LPBKD235GX-LPB OF SOLAR PHOTOVOLTAIC POWER MODULES Please read this guide carefully before installing the modules. [. . . ] The minimum spacing of . 6" (15 mm) is required between PV module and the mounting surface around the perimeter of PV module. There should also be a clearance of at least . 13" (3. 2 mm) between the individual modules to allow heat-related expansion. BOLTING: Utilizing 5/16" or 8 mm steel hardware structure through the existing . 35" (9 mm) diameter mounting holes in the module frame and then through KDxxxGX-LPB modules mounting holes on the support structure. Support structure should have enough strength to keep the mounting span. Refer to the below table for the position of PV module mounting holes. CLAMPING: Fasten modules firmly with the clamps which must not be deformed by wind load or snow load, nor cause the module fall off. [. . . ] Refer to the below table for the permissible clamping range. KKM-SM/2 KKM-SM-0542 2/2 Mounting table <KD225GX-LPB - KD235GX-LPB> Long side Bolting 281mm 1100mm 100mm 100mm 100mm 100mm Top down clamp : Permissible clamping range 281mm 1100mm [. . . ]