User manual KYOCERA FS-5900C

[. . . ] Thank you for purchasing the Kyocera FS-5900C Colour Laser Printer. Notice NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. The information in this manual is subject to change without notification. The user is asked to excuse any technical inaccuracies or typographical errors in the present edition. SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S NATIVE MODE OR ONE OF ITS EMULATION MODES. [. . . ] Or, the capacity of the memory card installed in the printer is more than 32 MB. The card is an S-RAM or flash card which cannot be used by this printer. This error code appears when an attempt is made to write more data on the memory card than available memory. To halt the writing of data, first stop data transmissions from the computer, and then press the printer's CANCEL key. Press the FORM FEED key if the message Waiting will appear in the message display. The number of data which can be written on the memory card is limited to 127. Pressing the CANCEL key will restore the message Ready in the message display. The flash memory card cannot be written due to insufficient printer memory. Either delete unnecessary macros and/or fonts stored in the printer, or expand the printer's available memory. Try substituting another flash memory card. MEMORYCARD err 01 Press CONTINUE MEMORYCARD err 02 Press CONTINUE MEMORYCARD err 03 Press CONTINUE MEMORYCARD err 04 Press CONTINUE MEMORYCARD err 05 Press CONTINUE MEMORYCARD err 06 Press CONTINUE MEMORYCARD err 07 Press CONTINUE MEMORYCARD err 09 Press CONTINUE MEMORYCARD err 11 Press CONTINUE MEMORYCARD err 13 Press CONTINUE MEMORYCARD err 17 Press CONTINUE MEMORYCARD err 18 Press CONTINUE 61 Using the Printer Setting the Sleep Timer The sleep timer can be set anywhere from 0 to 120 minutes in 5-minute increments. The sleep timer is set at the factory to 60 minutes. To set the sleep timer: 1 2 3 4 5 6 7 8 Press the MODE key on the printer panel. Press the + key repeatedly until the message display indicates Others>. Press the key. Press the + key repeatedly until the message display indicates >Sleep timer. The current sleep timer (in minutes) is indicated. Press the ENTER key. or Once the set time arrives, the printer will display Sleeping and all indicators will go out. This minimizes the amount of energy used. Resource Protection When you switch from the PCL 5C emulation to KPDL, all downloaded fonts and macros are lost. Resource protection preserves these PCL resources in memory so that they are intact when you change the emulation back to PCL 5C. By using the printer's >Resource prot. menu, you can select from two resource protection modes: 62 Using the Printer Permanent In this mode, the printer stores fonts, macros, symbol sets, etc. All temporary resources are lost when the emulation mode is changed from PCL 5C to KPDL or vice versa. Permanent and temporary In this mode, the printer stores both permanent and temporary resources when the emulation mode is changed from PCL 5C to another or vice versa. To select the resource protection mode: 1 2 3 4 Press the MODE key on the printer panel. Press the + key repeatedly until the message display indicates Others>. Press the key. Press the + key repeatedly until the message display indicates >Resource prot. The current resource protection mode is indicated -- Permanent or Perm/Temp. >Resource prot. Press the MODE key to exit the mode selection menu. 63 Care and Maintenance Cleaning Periodic cleaning of the printer is recommended. The frequency of cleaning is dependent upon the environment in which the printer is used. [. . . ] 5 Power switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Preparing the imaging unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Print HEX-DUMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 Print quality problems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]