User manual KYOCERA FS-1900

[. . . ] Table of Contents FS-1900 Page Printer Operation Guide Caution on Installation NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. Notice on Software SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The emulation mode can be changed by following the procedures described in Chapter 1. Notice on This Guide The information in this guide is subject to change without notification. The user is asked to excuse any technical inaccuracies or typographical errors in the present edition. No responsibility is assumed if accidents occur while the user is following the instructions in this guide. [. . . ] Press the or key repeatedly until >Page Protect appears. >Page Protect On Press the ENTER key. On 1-91 Configuration 6 7 8 Linefeed (LF) Action Press the or key repeatedly until Auto appears. >Page Protect ?The message display returns to Ready. This procedure instructs the printer what to do when it receives a linefeed code (character code 0AH). 1 2 3 4 5 6 Press the MENU key. Press the or key repeatedly until Page set > appears. Page set > Press the > key. Press the or key repeatedly until >LF Action appears. >LF Action LF only Press the ENTER key. LF only CR and LF Ignore LF or key repeatedly until desired linefeed action A linefeed is performed. The linefeed is ignored. 7 8 When the desired action is displayed, press the ENTER key. The message display returns to Ready. 1-92 Configuration Carriage-Return (CR) Action This procedure instructs the printer what to do when it receives a carriagereturn code (character code 0DH) 1 2 3 4 5 6 Press the MENU key. Press the or key repeatedly until Page set > appears. Page set > Press the > key. Press the or key repeatedly until >CR Action appears. >CR Action CR only Press the ENTER key. CR only CR and LF Ignore CR or key repeatedly until desired carriage-return action A carriage-return is performed. The carriage-return code is ignored. 7 8 When the desired action is displayed, press the ENTER key. The message display returns to Ready. 1-93 Configuration Wide A4 Pitch Turn this to On to increase the maximum number of characters that can be printed in a line for A4 page (78 characters at 10 pitch) and Letter size page (80 characters at 10 pitch). This setting is effective in only PCL 6 emulation. 1 2 3 4 5 6 7 8 Press the MENU key. Press the or key repeatedly until Page set > appears. Page set > Press the > key. Press the or key repeatedly until >Wide A4 appears. >Wide A4 Off Press the ENTER key. or key. 1-94 Configuration Print Density The print density can be adjusted in five steps: from 01 (light) to 05 (dark). Press the or key repeatedly until Print Quality > appears. Print Quality > Press the > key. Press the or key repeatedly until >Print Density appears. >Print Density 03 Press the ENTER key. 03 Select the print density from five steps from 01 (light) to 05 (dark) using the or key. The message display returns to Ready. 1-95 Configuration Total Printed Pages This procedure displays the total number of printed pages. 1 2 3 4 Press the MENU key. Press the or key repeatedly until Life Counters > appears. Life Counters > Press the > key. [. . . ] To print, proceed as follows. 1 2 Display the printer driver's Properties dialog box from the application software. Click the Output tab and then click the Job Settings button. The Job Settings dialog box will appear. 3-32 Printing from Windows Applications 3 Check the Job Storage (e-MPS) checkbox, and then check the Job Storage. 4 You can add security to the print job. To do so, check the Access Code checkbox and enter the desired 4-digit access code using any numbers between 0 and 9. You must enter this number at the printer operator panel when printing. 5 Click the OK button. [. . . ]