User manual KYOCERA FS1800N-

[. . . ] FS-1800/N FS-3800/N Page Printers Installation Manual Caution NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. Notice on Software SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The emulation mode can be changed by following the procedures described in the User's Manual contained as an electronic file in the CD-ROM supplied with the printer. Notice The information in this manual is subject to change without notification. The user is asked to excuse any technical inaccuracies or typographical errors in the present edition. No responsibility is assumed if accidents occur while the user is following the instructions in this manual. [. . . ] A label indicating compliance with the CDRH regulations must be attached to laser products marketed in the United States. Ozone concentration The printers generate ozone gas (O3) which may concentrate in the place of installation and cause an unpleasant smell. To minimize concentration of ozone gas to less than 0. 1 ppm, we recommend you not to install the printer in a confined area where ventilation is blocked. IMPORTANT SAFEGUARDS 1. Read all of these instructions and save these instructions for later use. Slots and openings in the cabinet and the back are provided for ventilation to ensure reliable operation of the product and to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation unless proper ventilation is provided. This product is equipped with a 3-wire grounding type plug, a plug having a third (grounding) pin. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. If an extension cord is used with this product, make sure that the total of the ampere ratings on the products plugged into the extension cord do not exceed the extension cord ampere rating. 6. 7. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Except as explained elsewhere in User's Manual, do not attempt to service this product yourself. Removing covers may expose you to dangerous voltage points or other risks. Unplug this product from the wall outlet and refer servicing to qualified service person-nel under the following conditions: A- When the power cord or plug is damaged or frayed. D- If the product does not operate normally when the operating instructions are followed. Adjust only those controls that are covered by the operating instructions since improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation. E- If the product has been dropped or the cabinet has been damaged. Canadian Department of Communications compliance statement This Class B digital apparatus complies with Canadian ICES-003. (FS-1800/FS-3800) This Class A digital apparatus complies with Canadian ICES-003. (FS-1800N/FS-3800N) Avis de conformité aux normes du ministère des Communications du Canada Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. (FS-1800/FS-3800) Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. (FS-1800N/FS-3800N) ISO 7779 Maschinenlärminformationsverordnung 3. GSGV, 18. 01. 1991: Der höchste Schalldruckpegel beträgt 70 dB(A) oder weniger gemäß ISO 7779. CE Marking Directive According to Council Directive 89/336/EEC and 73/23/EEC Manufacturer's name: Kyocera Mita Corporation, Tamaki Plant Manufacturer's address: 704-19 Nojino, Tamaki-Cho, Watarai-Gun, Mie-Ken 519-0497, Japan declares that the product Product name: Page Printer Model number: FS-1800/FS-3800/FS-1800N/FS-3800N (as tested with the enhancement optional unit: PF-60, DU-60, and SO-60) Conforms to the following product specifications. [. . . ] Neither party may bring an action, regardless of form, more than two years after the cause of action arose. If you acquired the Program in the United States, this license is governed by the laws of the State of New York. If you acquired the Program in Canada, this license is governed by the laws of the Province of Ontario. Otherwise, this license is governed by the laws of the country in which you acquired the Program. Important note on the interface connectors Be sure to turn off printer power before connecting or disconnecting an interface cable to the printer. [. . . ]