User manual KYOCERA DP-410 INSTALLATION GUIDE

[. . . ] Connect signal line (5) of DP (A) to the MFP and turn fixing knobs (6) at the both sides of the connecter clockwise to secure the line. Adhere label "Operation procedure" (C) of which the language corresponding to the destination of the MFP on to the existing label of the original feed unit cover. " (D) of which the language corresponding to the destination of the MFP on to the label of the original delivery table. [. . . ] " (D) of which the language corresponding to the destination of the MFP on to the label of the original delivery table. " (E) of which the language corresponding to the destination of MFP on to the label of the original table. To check the machine operation, prepare original (a) where 4 lines (b) are drawn 20 mm from the edges of the A3 sheet and 1 line (c) is drawn at its center. Connect the power plug of the MFP into the wall outlet and turn the main power on. Set the original (a) on the DP and perform a test copy to check the operation and the copy example. If the gap exceeds the reference value, perform the following adjustments according to the type of the gap. <Reference value> Single copying: within ±3 mm; Duplex copying: within ±4 mm For the adjustment of DP original size, see page 9. <Reference value> Single copying: ±2 mm; Duplex copying: within ±3 mm When using the DP auto adjusting original, automatic adjustments excluding the DP oblique position adjustment can be performed. Check the gap between line (1) on original (a) and line (2) of copy example. If the gap exceeds the reference value, adjust the gap according to the following procedure. For the faster leading edge timing, copy examples (h): Decreases the value. Repeat the steps 1 to 3 above until the gap of line (2) of copy example shows the reference value. Check the gap between center line (1) on original (a) and center line (2) of copy example. If the gap exceeds the reference value, adjust the gap according to the following procedure. <Reference value> Horizontal difference of center line (2) for the single copying: ±2 mm Horizontal difference of center line (2) for the duplex copying: ±3 mm Set the maintenance mode U072, and adjust the copy example for each of single and duplex copying respectively. If the center moves more front, copy example (j): Increases the value. [. . . ] If the gap exceeds the reference value, adjust the gap according to the following procedure. <Reference value> Horizontal difference of center line (2) for the single copying: ±2 mm Horizontal difference of center line (2) for the duplex copying: ±3 mm Set the maintenance mode U072, and adjust the copy example for each of single and duplex copying respectively. If the center moves more front, copy example (j): Increases the value. [. . . ]