User manual KYOCERA DF-710

[. . . ] BE VERY CAREFUL to avoid getting your fingers caught in or burned by the finisher when clearing a paper jam. Avoid placing this product on or in locations which are unstable or not level. this type of situation presents a danger of personal injury or damage to the product. Avoid locations near radiators, heaters, or other heat sources, or locations near flammable items, to avoid the danger of fire. [. . . ] The following paper sizes can be used in Booklet Stitching mode: · Booklet Feature (Sheet originals): Delivers booklet of two-sided copies with facing pages from one-sided or two-sided originals. Booklet Feature (Facing originals): Copies book originals to booklets consisting of two-sided copies with facing pages. Hole Punch mode can be used with Sort: ON, Staple and Sort: OFF modes. The following paper sizes can be used: Inch models · Paper weights must be between 45 g/m2 and 200 g/m2. The copies are automatically hole punched and ejected onto the selected tray. NOTE: Holes are punched in each copy individually, therefore the location of the holes may vary on each sheet. Take out the any existing original and set the original to use for interrupt mode. When done copying in interrupt mode, turn off interrupt copy mode from the machine itself. This feature is useful when sharing the printer among multiple computers to output paper to specific trays for each user. The following paper sizes can be used: A3, B4, A4, A4R, B5, B5R, A5R, Folio, 11 × 17", 8 1/2 × 14", 8 1/2 × 13 1/2", 8 1/2 × 13", 11 × 8 1/2", 8 1/2 × 11", 5 1/2 × 8 1/2", 8K, 16K and 16KR NOTE: The maximum number of copies that can be stored in each tray will differ Depending on the size of copy paper being used. Write the name of the user of each tray on the labels provided and attach the labels to the side of each tray. The bins to which labels should be applied are 1, 2, 3, 4, 5, 6, 7 as counted from the top down. Use the printer driver on your computer to select a mailbox tray (mailbox) between 1 and 7. Select the paper size, page(s) to be printed and number of prints required. On the full color machine, the output tray can be specified with the copy and fax functions. On the monochrome machine, the output tray can be specified with the copy, fax, and printer functions. If a message displays indicating that staples have run out, the staple cartridge holder need to be replenished with staples. NOTE: If the Staple Unit runs out of staples, contact your service representative or the Follow the steps below to refill staples. While pushing the finisher release lever, pull the finisher out from the machine. The staple cartridge holder will click into place when it has been inserted correctly. Close the right cover (D8) and re-install the finisher back into position on the machine. Follow the steps below to refill staples for the optional folding unit. [. . . ] Open the cover plate (A) of the staple cartridge holder A and remove any jammed staples. Close the cover (A) plate of the staple cartridge holder into its original position. The staple cartridge holder will click into place when it has been inserted correctly. Close the right cover (D8) and re-install the finisher back into position on the machine. [. . . ]