User manual KRUPS YY8308 FD

[. . . ] ρ® For your safety, this appliance complies with standards and applicable regulations (Low Voltage Directives, Electro-magnetic compatibility, Materials in contact with foodstuffs, Environment, . ρ® This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capacities or lack of experience and knowledge, unless they are supervised or have been given instructions beforehand concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. ρ® Before plugging in your appliance, check that the power voltage of your appliance corresponds to that of your mains installation and that the plug does have an earthed connection. [. . . ] The appliances are pre-programmed to keep the coffee warm for 2 hours. Press the keep warm button "KEEP WARM" (t) to select either 1, 2, 3 or 4 hours. This function allows the coffee to be kept warm before the coffee maker switches off automatically. B – After the infusion cycle:  As soon as the infusion cycle is over, a timer will start. ρ® You can change the duration of the keep warm function at any moment, within a period of a maximum of 4 hours. To interrupt this function, you only need to press the start/stop button “ON/OFF” at the end of the cycle. 18 KR_COFFEE-MAKER_ARUBA_EO_Mise en page 1 18/10/11 17:07 Page19 English AROMA FUNCTION This function allows a better extraction of the ground coffee to get the best possible flavoured coffee. Even if the aroma function is still on, its effect on the taste of the coffee is more perceptible when you make small quantities of coffee. ρ® To activate the aroma function, press the button “STRONG” (p) Fig. Please Note: - This function can be activated at any moment during the programming. - This function cannot be modified once the infusion cycle has started. COFFEE SERVER 1 ) WAYS OF SERVING YOUR COFFEE Depending on how you like your coffee, you can use the buttons “MANUAL” (manual service) (v), “LARGE” (large size) (u) or “SMALL” (small size) (w) for serving a cup of coffee. a – Manual service  Press the button “MANUAL” (v) Fig. The appliance is pre-programmed at the factory to the following quantities: - « LARGE » = 240 ml - « SMALL » = 120 ml  You can personalise this volume. To do this, just press the button “LARGE” (u) and “SMALL” (w) and keep it held down to adjust the volume of coffee per cup. When you have obtained the required quantity, release the button to enter the new setting. The next time you use your coffee maker it will remember the volume you have programmed. ρ® The next time you use the SMALL or LARGE button, press briefly. If you keep the button pressed down for too long, you’ll change your setting again. Please Note: You can check the quantity of coffee which is left in the reservoir using the window located on the front of the appliance. CUP REST TRAY  There are three levels possible for adjusting the height you want your cups to be at Fig. ρ® This cup rest tray will collect any coffee that may overspill. [. . . ] ρ® Some of the ground coffee has found its way in between the filter paper and the filter carrier. ρ® Rinse the filter-carrier before putting the filter paper in it so that the filter paper sticks to the damp walls of the filter carrier. ρ® There is more than one filter paper in the filter carrier. ρ® Warm up the coffee container (i) by rinsing it in warm water just before switching it on. [. . . ]