User manual KRUPS YY8123FD

[. . . ] Please check your guarantee card for more details on the guarantee conditions in your country, with a maximum of 3000 cycles a year. This appliance is intended for domestic use only and is not suitable for commercial or professional use. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. The guarantee expressly excludes espresso machines that do not work or which work poorly because they have not been cleaned or descaled, or because there are foreign bodies in the grinder. [. . . ] FROTHING MILK We recommend that you use pasteurised or UHT milk that has been recently opened. After the steam function has been used, the nozzle can be hot, and we recommend that you wait for a few moments before handling it. To remove any remaining milk from the steam nozzle, place a receptacle under the nozzle and press the key. Let the steam escape for at least 10 seconds and then again press the key to stop the process. Wash it out with water and a little washing up liquid and a small non-abrasive brush. Before putting it back, ensure that the air inlet holes are not blocked by any milk residues. The maximum duration for production of steam per cycle is limited to 2 minutes. SETTING UP THE AUTO-CAPPUCCINO XS 6000 (SOLD SEPARATELY) This auto-cappuccino accessory makes it easier to make a cappuccino or a caffe latte. Fill up the milk pot and place a cup or a glass underneath the autocappuccino nozzle. Press the button to start and then to stop the cycle Place your cup under the coffee outlets and start a coffee / espresso cycle. To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly. It is recommend that you wash it immediately by carrying out a cycle with steam and the accessory pot filled with water in order to clean the inside of the nozzle. To do so, you can use liquid cleaner XS4000, available as an accessory. 7 MAINTAINING YOUR APPLIANCE EMPTYING THE COFFEE GROUNDS COLLECTOR, THE COFFEE TRAY AND THE DRIP TRAY The drip tray receives waste water and the coffee grounds collector receives used coffee grounds. The coffee cleaning tray allows you to eliminate any deposits of coffee grounds. As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow. The light will remain on if the coffee grounds collector is not slotted in fully or not fitted correctly or if it has been put back in less than 4 seconds. You cannot make espresso or coffee while the light is on or is flashing. RINSING OUT THE COFFEE CIRCUIT: SEE PAGE 5 MACHINE CLEANING PROGRAM – TOTAL DURATION: ABOUT 20 MINUTES When a cleaning operation is necessary, the appliance warns you of this by flashing the "clean" light. To benefit from the guarantee conditions, it is essential to perform the appliance cleaning cycle when informed to do so. You can continue to use the appliance when the light is on, but you are advised to perform the program as soon as possible. Press the ‘Service’ button to start up the cleaning program. [. . . ] After having turned the machine off and left it to cool Clean and unblock all of the openings in the nozzle using the needle supplied (cf page 7). Check that the steam comes out of the nozzle, dry the little air inlet at the top of the nozzle if necessary. Check that the 2 ends of the small stainless steel tube in the flexible part of the steam nozzle are fitted together properly. The machine has not produced any coffee You used ground coffee instead of coffee beans. [. . . ]