User manual KRUPS OBLO YY2291FD

[. . . ] Q Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. call KRUPS Consumer Service Department (see GUARANTEE OF PERFORMANCE) for repair procedure. Q The use of accessory attachments not recommended or sold by KRUPS may result in fire, electric shock or personal injury. Q Do not let cord hang over edge of table or counter, or touch hot surfaces. [. . . ] If you want to set the quantity of espresso or coffee for a particular size of cup, then turn the cup-fill knob before the operation to the position and then prepare the espresso or coffee. When the cup is sufficiently full, turn the knob in the flow of liquid stops. The quantity for two cups is always automatically twice as much as for one cup. When the rinsing process is finished, the following lamps will glow: "rinse"; "1 cup normal"; "1 cup strong"; "2 cups"; "coffee-meal". You can raise or lower the delivery pipe to suit the size of your cups (15). (Remember that you can change the degree of coarseness during the actual grinding). Following this, the coffee-meal will be moistened with a little water for the prebrew. After a short pause, the proper brewing operation will be carried out. Note: If you press the key, you will obtain one cup of strong espresso or coffee. The simultaneous preparation of two cups of strong espresso or coffee is not possible. If you accidentally actuate the key, you can cancel the action by pressing the or the key. S Place a cup beneath the steam nozzle and turn the selector knob for steam/hot water to the position. S When the cup is sufficiently filled with hot water, return the selector knob to the position. A rinsing operation will then be automatically carried out, after which the appliance will switch itself off. Note: This rinsing operation will also be carried out when the pre-set automatic switch-off mechanism comes into play. S Always pull out the mains plug before any cleaning operation and allow the appliance to cool down. S Clean the drawer, drawer attachment, spent coffee holder and base grid with warm water and washing-up liquid (25). S Clean the steam nozzle immediately after the milk-frothing operation by allowing the appliance to produce steam for 1-2 seconds, thus blowing any residue out of the nozzle. Where necessary, the steam nozzle can be screwed out in an anticlockwise direction using the hexagonal key on the measuring spoon, after which it can be thoroughly cleaned (26). If the small suction opening in part A has become blocked, you can poke it clear it with the aid of a needle. You must carry out the cleaning programme after 250 preparations of espresso or coffee, or after 180 rinsing operations. provided the appliance is switched on , this requirement will be announced by the glowing of the "clean appliance" indicator. [. . . ] S When the "empty spent coffee holder" indicator glows, take out and empty the drawer with the spent coffee holder. The rinsing procedure will continue and the water will run intermittently into the drawer. Appliance indicator(s) Note: If there is too little water for the rinsing operation in the water tank, the "fill water tank" indicator will glow. Note: If, during the course of the de-scaling programme, the key is pressed, or if there is a power failure, the programme will have to be restarted from the beginning. [. . . ]