User manual KRUPS NESPRESSO PROGRAMATIC 554

[. . . ] S Do not use the appliance when the container is not filled with water. S Do not remove the capsule holder during the brewing process as the appliance is then under pressure. S Do not use the appliance when the drip tray and cup grid are not pushed in. S The mains plug must be pulled out if anything untoward occurs during the brewing operation, as also before every time the appliance is cleaned. [. . . ] Should you wish to alter the pre-programmed quantities of liquid for large or small cups, please proceed as follows: s Switch on the appliance. S As soon as the red control lamp glows steadily, press the memory key . The -key green control lamp will blink and the green control lamps for large and small cups will glow steadily (15). S Press and hold down the key until the desired quantity of espresso has been reached (16). S Now press the -key to stop the flow of espresso and to store this quantitiy in the memory (17). To programme the quantity for a large cup, just repeat this process using the key. With this appliance, you can prepare hot water for tea, instant coffee, bouillon and the like. S As soon as the red control lamp glows steadily, swing out the steam and hot water nozzle and place a suitable vessel beneath it. If you do not actuate the rotary valve in the next 2 minutes, the appliance will return to ist normal operating mode. S As soon as there is sufficient water in the vessel, return the rotary valve to the q position. S Now remove the vessel and swing the steam and hot water nozzle inwards over the cup grid so that any further drops of water can fall into the drip tray. In order to achieve the optimum frothing-up, you should use the separate frothing attachment. 5 litre capacity) which must pass easily under the steam nozzle of the machine. The jug you use should also be cooled, so do not rinse it out beforehand with warm water. First of all prepare the espresso, making the cappuccino cup only half full of espresso. The red operation control lamp and the green steam control lamp will both blink. As soon as the red control lamp glows steadily, the appliance has reached the temperature necessary for the production of steam. If you do not actuate the rotary valve in the next 2 minutes, the appliance will return to ist normal operating mode. dip the steam and hot water nozzle into the vessel containing the milk. In doing this, hold the jug under the nozzle in such a way that the nozzle itself dips right into the milk (21). Turn the rotary valve to the position and hold the jug steady during the frothing operation. The nozzle must not touch the bottom of the jug, so as not to impede the flow of steam. [. . . ] For a thorough cleaning, the frothing aid can be taken apart by pulling parts A and C from the metal tube B (25). Should the small suction orifice in part A be blocked, it can be pierced with a needle. Then remove the capsule cage by screwing it off in an anti-clockwise direction with the capsule holder and the capsule cage key (28). Clean both holes on the nozzle of the capsule cage with the help of the nozzle cleaner (29). [. . . ]