User manual KRUPS KT50

[. . . ] 10 - To reduce the risk of injury do not drape cord over the counter top or table top where it can be pulled on by children or tripped over unintentionally. 12 - The use of accessory attachments not recommended by KRUPS may result in fire, electric shock or injury to persons. 14 - Do not place on or near a hot gas or electric burner, or in a heated oven. 15 - To disconnect the machine, turn the control to "OFF", then remove plug from wall outlet. [. . . ] The LCD will display a different function for each time the PROG is pressed. The blinking display and the icon alerts you that the unit is in a programming mode. After pressing the PROG button the screen should default back to the stand-by mode after 5 seconds of inactivity, accepting the last programmed settings for auto-on and auto-off. Press PROG (r) once, the AUTO program #1 is indicated with a red light (o). You can press and hold the buttons to move quickly through the hours or minutes. You can press and hold the buttons to move quickly through the hours or minutes. Press PROG (r) twice, the AUTO program #2 is indicated with a red light (o). This second preset start time can be used for days with later wake times, ie weekends. After programming the automatic start time as described above, be sure to prepare the machine for a brew cycle with water in the tank, coffee in the brew basket, lid closed and carafe securely in place. Press PROG (r) 3 times, the number of hours will blink and the 2 red lights (o) on the control panel will blink. This function controls how long the heating plate will continue before automatically turning off. For best results we recommend brewing only as much coffee as you will consume in 30-60 minutes. Taste is affected the longer the coffee is allowed to sit on the heating plate. This function is designed specifically for small batches, normally less than 6 cups, where brew cycles become too short to properly extract the coffee taste from the coffee ground. Note : this function cannot be changed once the brew cycle has started. The function can also be used for full pots but will cause more of the bitter flavors to be extracted in that case. Krups recommends only using Aroma Control for small batches less than 6 cups. note: there is a rotary indicator on the top of the water filter holder. Place the index mark next to the month the filter should be changed, referring to the chart below. Water type Soft water Hard water about 120 about 80 Uses 4 months 2 months · Example: if you replace the DuoFilter in January (1) you should set the indicator to March (3) or May (5), depending on the hardness of your local water supply: position the number 3 or 5 opposite the index mark. important: · The DuoFilter must only be used with water. ⷠThe coffee machine still functions if the water filter is not in place. [. . . ] Krups Service Centre locations can be found by visiting the website www. This Krups product is warranted for 1 year from the date of purchase against defects in material and workmanship. During this period, the Krups product that, upon inspection by Krups, is proved defective, will be repaired or replaced, at Krups option, without charge to the customer. if a replacement product is sent , it will carry the remaining warranty of the original product. [. . . ]