User manual KRUPS KM5055 10

[. . . ] Qxd 5/03/09 10:35 Page 15 DESCRIPTION a b c d e f g h i j k l m n o p q r Top lid Open button Control panel Cord storage Heating plate / base (according to model) Glass jug or thermal pot (according to model) Water level indicator Cone filter holder Water filter change indicator (according to model) Water filter holder (according to model) DuoFilter (according to model) Display On/Off Auto-on manual brewing selection button Auto-on LED Hours and minutes setting buttons Aroma function Programming button English IMPORTANT PRECAUTIONS • • • • • • • • • • • • • • • Read the instructions carefully before you start using your machine: any use which does not conform to these instructions will absolve Krups of any liability. Do not leave the machine within reach of children without supervision. The use of this machine by young children or by disabled people must always be supervised. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] The blinking display and the icon alerts you that the unit is in a programming mode. After pressing the PROG button the screen should default back to the stand-by mode after 5 seconds of inactivity, accepting the last programmed settings for auto-on and auto-off. Press PROG (r) once, the AUTO program #1 is indicated with a red light (o). Press the H and Min buttons (p) to set a time for the machine to brew automatically. You can press and hold the buttons to move quickly through the hours or minutes. 14 & 15 2- Auto-On setting #2: Press PROG (r) twice, the AUTO program #2 is indicated with a red light (o). This second preset start time can be used for days with later start times, ie weekends. After programming the automatic start time as described above, be sure to prepare the machine for a brew cycle with water in the tank, coffee in the brew filter holder, lid closed and jug securely in place. 3- Auto-Off setting (only for model with glass jug): Press PROG (r) 3 times, the number of hours will blink and the 2 red lights (o) on the control panel will blink. This function controls how long the heating plate will continue before automatically turning off. For best results we recommend brewing only as much coffee as you will consume in 30-60 minutes. Taste is affected the longer the coffee is allowed to sit on the heating plate. AROMA FUNCTION This function is designed specifically for small batches, normally less than 6 cups, where brew cycles become too short to properly extract the coffee taste from the coffee ground. Note : this function cannot be changed once the brew cycle has started. The function can also be used for full pots but will cause more of the bitter flavours to be extracted in that case. Krups recommends only using Aroma Control for small batches less than 6 cups. The anti-chlorine action of the filter brings out the most delicate flavours of the coffee. Note: there is a rotary indicator on the top of the water filter holder. Place the index mark next to the month the filter should be changed, referring to the chart below. Water type Uses Replace Duo Filter every : Hard water Soft water about 120 about 80 4 months 2 months • Important: • The DuoFilter must only be used with water. € The coffee machine still functions if the water filter is not in place. € If the coffee machine has not been used for more than one month, rinse the DuoFilter under running water. [. . . ] Qxd 5/03/09 10:35 Page 23 PROBLEM The filter holder (h) overflows or the coffee drips too slowly. We recommend that you use one measuring spoon or one tablespoon of coffee ground per cup. The coffeepot (f) was removed for more than 20 seconds during brewing and was not correctly put back on the hot plate (e). Some coffee grounds have seeped in between the paper filter and the filter holder (h). [. . . ]