User manual KRUPS IL CAFFE PRESSO

[. . . ] Allowto cool before putting on or taking off parts, and before cleaning the appliance. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged inany manner. Return appliance to an authorized service facility for examination, repair or adjustment. "t:heuse of an accessory not evaluated for use with this appliance may cause -injuries. [. . . ] Following this procedure will prevent the filter holder from being dislodged as pressure builds up during the brewing process. Unscrew the boiler cap (a) by turning it counter clockwise (see figure 4). Using the glass carafe, fill the boiler chamber with fresh, cold water (see figure 5). Measuring Guidelines The glass carafe (i) has markings for 2 cups and 4 cups and steaming. 2 cups of water yields 2 cups of espresso, 3 cups of water yie'lds 2 cups espresso, plus steam for frothing l"I'Iilk for cappuccino. 5-51/2 cups of water yields 4 cups of espresso, plus steam for frothing milk for cappuccino. 5-51/2 cups of water is the upper rim of the metal band surrounding the carafe. It should be in the "0" (off) position. Place the boiler cap (a) on the machine and turn it clockwise until it is secure (see figure 6). Next, place the carafe lid on the carafe (i) so that the opening points towards the pouring spout on the carafe (see figure 7). Make sure that the nozzle in the filter holder points through the opening of the carafe lid (see figure 8). To make espresso directly into the cups, clip the cup adapter (g) onto the filter holder (see figure 9). The machine can be wiped Ifclogging does occur, unscrew the tip' of the steam nozzle (see figure 15). However, in areas where there is hard water or if used very frequently, we recommend decalcifying, especially if white deposits can be seen in boiler chamber. Decalcifier is widely available and can be purchased from KRUPS Consumer Service Department. How To Decalcify Please follow the procedure listed below to decalcify your machine: . Remove filter holder, glass carafe, and over, flow from the grid machine. With a flat blade screw driver, remove the brewing head sieve by turning it clockwise until the sieve can be removed from the machine (see figure 17). Pour this solution into the boiler container and secure the boiler cap. . . Place the glass carafe without the lid underneath the brewing head. Espresso does not come out positionsothat Cause: . . the solution will pass through the water heating system into the glass carafe. Repeat the above process using clean, cold water to remove all the remaining solution in the machine. Nowatern boiler i . con- tainer No coffeein filter holder because coffee is ground too fine and or pressed down to hard . Steam does not come out of steam nozzle Cause: PROBLEMS ANDCAUSES MAKINGESPRESSO OR CAPPUCCINO (Always check ifthe appliance is plugged in and is in the proper "On" position). [. . . ] Tum "on" your "ILCaffe Grande" using the "Onl Off' button. The indicator lightwillilluminate indicating that the brewing process has begun /see figure 7). As long as the red indicator lightis illuminated the coffee willbe k:ept warm. agents. Never immerse the appliance itself in water. Never use a cloth to clean inside of the water chamber, as this might leave fuzzydeposits in the chamber. [. . . ]