User manual KRUPS ESPRESSO BRAVO PLUS

[. . . ] 0 Do not unscrew or remove boiler cap while the machine is in operation. Wait until brewing cycle is completed and all water and steam has been released. Do not use a cracked carafe or a carafe having a loose or weakened handle. Do not clean carafe with cleansers, steel wool pads, or other abrasive material. SAVE THESE INSTRUCTIONS CAUTION This appliance is for household use. [. . . ] If the arrow is not at least in the middle of the lock range, do not operate the machine. Rather, remove the filter holder and reinsert it as described above until the arrow is within the lock range (see figure 3). Once the filter holder is properly in place, it should never be moved or attempted to be removed while the "Espresso Bravo Plus" is in operation and under pressure. Unscrew the boiler cap by turning it counter clockwise (see figure 5). Using the glass carafe, fill the boiler container with fresh, cold water (see figure 61. A CAUTION: Never fill the boiler while your "Espresso Bravo Plus" is in the u p y or " @?I " position. Never fill the water past the top of the metal band on the glass carafe. l/4 cup) to compensate for evaporation and absorption during the brewing process. However, do not fill past the top of the metal band on the glass carafe. The glass carafe (e) has markings on it for 2 cups and 4 cups of espresso and steaming: - 2 cups of water yields 2 cups of espresso. - 3 cups of water yields 2 cups of espresso, plus steam for frothing milk for cappuccino. - 5 cups of water yields 4 cups of espresso, plus steam for frothing milk for cappuccino. Place the boiler cap securely on the machine and turn it clockwise until it is secure (see figure 7). Place the carafe lid (dj on the carafe (e) so that the lid opening points toward the pouring spout of the carafe (see figure 8). Make sure that the nozzle in the filter holder points through the opening of the carafe lid (see figure 9). To make espresso directly into one or two cups, clip the cup adapter (hj onto the filter holder before brewing (see figure 10). Simply turn the selector switch to the " Q " position (see figure 12). After approximately 2 minutes the water will have reached the proper temperature. The water will automatically pass through the coffee grinds, producing espresso in the glass carafe or in the cups, whichever you selected. If, after 4 minutes, no water passes through the coffee grinds, turn Off the machine, release pressure by following the instructions under CAUTIONPRESSURE listed below, then remove the filter holder, empty coffee grinds and start from the beginning. ATTENTION: Depending on the degree of finess of the coffee ground it can occur that the brewing process will be interrupted once. - 4 cups of water yields 4 cups of espresso. Once the coffee has stopped the complete brewing process, turn OFF the machine by moving the switch to the "0" position. Before you remove the filter holder for cleaning, make sure that the boiler is no longer under pressure (see section CAUTION-PRESSURE). [. . . ] I "Perfect Froth" attachment is clogged (see "Cleaning the Perfect Froth"). Your KRUPS #872 is covered by the following warranty: If from date of purchase within one year this KRUPS product fails to function because of defects in materials or workmanship, KRUPS North America will, at its option, repair or replace the unit without charge, provided the owner has a proof of date of purchase. This warranty will be void if malfunction was caused by damage to the product by accident, misuse, use on frequency or voltage other than marked on the product and/or described in the instructions, abuse including tampering, damage in transit, or use for commercial purposes. This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. GUARANTEE OF PERFORMANCE This fine KRUPS product is manufactured according to a rigid code of quality standards, and, with minimum care, should give years of satisfying service. However, should the need arise for repairs or for replacement parts within or after the warrantv period, please call our CONSUMER SERVICE DEPARTMENT: (800) 526-5377 24-hours a day, 7 days a week You will be provided with specific instruction on how to get your product repaired, as well as the name and address of your nearest authorized KRUPS Service Center. [. . . ]