User manual KRUPS 996

[. . . ] 6- Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Return appliance to your nearest authorized KRUPS Service Center for examination, repair or adjustment (see Limited Warranty). 7- The use of an accessory not evaluated for use with this appliance may result in fire, electric shock or injury to persons. 9- Do not let cord hang over edge of table or counter or touch hot surfaces. [. . . ] In that case you need to turn the selector knob (S) in OFF middle position before making a new coffee cycle. You can also turn the selector off as soon as the coffee is ready. Serve» can not function. The «Pause and Serve» mechanism is opened as long as the glass carafe is inserted into the machine and sits properly on the warming plate and the swivel filter is closed properly. When brewing coffee make sure the glass carafe is in place (see «Pause and Serve» section). Place your appliance near an electrical outlet and release enough cord so that you can plug in the machine (2). Putting in the ground coffee 1. Swing out the filter holder (3) and insert a paper filter in the filter basket. When inserting a paper filter make sure the seam is pointing toward the base of the filter holder (4). Use your hands to conform the filter to the contours of the filter basket. We suggest using one level KRUPS measuring spoon of ground coffee for each cup of robust brewed coffee. We do not recommend using coffee that is ground to a powder-like consistency, as this will prevent water from passing through the filter. ATTENTION : Make sure that the filter paper does not fold over when closing the swivel filter, otherwise the water might run between the filter paper and the filter holder producing a very weak cup of coffee. If the filter holder's handle does not point toward you in lock position, do not operate the machine. Rather, remove the filter holder and reinsert it as described above (13). By following this procedure this will prevent the filter holder from being dislodged as pressure builds up during the brewing process. 5. Open the hinged lid and unscrew the boiler cap by turning it counterclockwise (14+15). 6. Fill the boiler container with cold water using the marking indicated on the glass carafe (16). Never fill more than 20 oz of water into the boiler. The glass carafe has markings for 2 and 4 cups. To froth milk for Cappuccino preparation, add the quantity of water corresponding to the steam level marking on the carafe. Maximum capacity to the bottom of the metal band around the glass carafe = 4 cups of espresso, plus steam for frothing milk for cappuccino. NOTE It is very important to fill only the amount of water you need into the boiler. Your appliance will always need to process all the water until the boiler is empty. 8. Place carafe under the filter holder and make sure the slot on carafe lid is right below the filter holder output (18). [. . . ] 1. Remove all lime and coffee residues from the brewing sieve and the brewing head. As descaling agent we recommend the use of reference solution N°F054 from Satisfusion 1 Service at 888-344-0727. 15 XP1500/1530 US/F/E. PM6. 5 15 16/03/05, 10:52 3. Dissolve a packet of Krups descaling solution in 10 oz / 300 ml of lukewarm water and pour into the boiler container. Put one receptacle under the brewing head and another under the steam nozzle. (Note : Do not use the filter holder during decalcification. ) 4. Open the steam valve and turn on the appliance. [. . . ]