User manual KRUPS 963

[. . . ] ⷠDo not use the appliance when the drip tray and the grid are not in place. ⷠUnplug the appliance if a problem occurs while the coffee is running through or before cleaning it. ⷠDo not unplug the appliance by pulling on the cord and do not place the cord on a sharp edge or the corner of an item of furniture. Avoid contact with the hot parts of the Keep out of reach of children and do not allow the cord to hang down. [. . . ] Fill the cups with boiling water and reset the pump switch to position . Insert the appropriate fillter (for one or two cups) into the filter holder (10). ⷠRemove any coffee from the edges of the filter holder (13). Prepare the espresso by turning the pump switch to the « » position (15). ⷠWhen a sufficient quantity has run through, reset the pump switch to position . ⷠAfter making the espresso, remove the filter holder and throw away the coffee grounds (16). If the water boiler empties itself during the preparation of the steam (steam stops coming out of the evacuation pipe), it must be refilled. ⷠTo do this, turn the steam tap to position O, place a container under the percolation head and set the pump switch to the « » position. ⷠAllow the water to flow from the percolation head until the yellow light goes on ; then reset the pump switch to position . ⷠWait until the yellow light has gone out before resuming steam production by slowly turning the steam tap to the max position. Steam can be used to make the milk frothy for a cappuccino or for heating liquids. ⷠDo not clean the filter holder or the cup rest grid in the dishwasher. ⷠIf the percolation head is very dirty, unscrew the percolation head using a coin : the valve spring and sealing gasket will also come off. ⷠClean the grid and wipe the percolation head with a damp cloth. Make sure the valve spring and the sealing gasket are correctly positioned (21). Important : After making frothy milk, clean the steam nozzle immediately by allowing the appliance to produce steam for 1 to 2 seconds. If the pipe and the tip have been completely obstructed, clean these using a needle. If necessary, this part of the nozzle can be unscrewed using the hexagonal key found on the measuring spoon and by unscrewing it in an anticlockwise direction. The nozzle must be screwed back on in a clockwise direction after cleaning. Use the key carefully when screwing it back on, and do not over-tighten. The cappuccino accessory can be given a thorough cleaning as follows: · If the tiny aspiration hole of part A is blocked, unblock it using a fine needle. If the appliance is not to be used for a long period, do not leave the filter holder in the percolation head, as this will cause unnecessary wear on the gasket and shorten its lifetime. [. . . ] Then reset the steam tap to O position and allow the remainder of the water to run through via the percolation head. ⷠUnscrew the valve spring and the gasket from the percolation head and replace the percolation grid with the valve spring and the gasket on the percolation head. Very loud noise from the pump Ground coffee too Use fresh ground old or very dry and coffee. See the paragraph «Cleaning » and try using a coarser ground coffee. [. . . ]