User manual KRUPS 468

[. . . ] s Never open the appliance while coffee is running through, as the appliance is then under pressure. s The glass jug is not suitable for use in microwaves, above open fire or on stove plates. s Do not refill the appliance whilst it is still hot; it takes about ten minutes to cool down. [. . . ] s Press the safety button and SLOWLY open the sealing lever, so that any residual pressure in the system can be released (8). The occasional cloudy appearance of the coffee can be caused by the quality of the water, the type of coffee used or by the degree of coarseness of the ground coffee. If the filter process takes noticeably longer than usual, look to see whether the appliance needs to have limescale removed. (see "Removal of Limescale"). Making coffee Plug the machine into the mains. The glass jug is marked in cups to help you to measure the amount of water required. 1, diameter 94 mm) If you moisten the filter paper slightly after placing it in the filter, you will avoid getting coffee meal between the filter paper and the filter itself at the beginning of the filtering process. You can measure the required quantity of coffee powder with a coffee measure. Spread the ground coffee evenly over the filter paper and press down lightly. If you are making only 2 or 3 cups we recommend laying a second filter paper on top of the coffee. The coffee will then be as strong and aromatic, as when making the maximum number of cups. s Place the cover plate on the water container with the handle pointing towards the rear (4). The rubber sealing ring of the water container must be completely enclosed. Locating the glass jug and filter: s The handles of the filter lid, the filter itself and the jug must all interlock (5). s Push the jug into the appliance from the front, until the handle of the cover touches the framework above. Only so can one be sure that the brewing jet is Keeping the coffee hot The machine's heating element continues to work until the machine is switched off. To keep the jug hot, just replace it in the machine and close the sealing lever. The coffee is kept hot at drinking temperature. Flex storage s This appliance is furnished with a convenient flex storage arrangement on the under side of the appliance (9). Cleaning Never dip the main part of the appliance into water. Always pull out the mains plug and allow the appliance to cool down before any cleaning operation. [. . . ] Dependant upon the degreee of calcination, repeat the operation 2-3 times with the same still hot solution, after which allow 2 glass jugfuls of clear water to run through. Disposal Changing the seals If after a lengthy period of use the water container cover, the filter lid or the hot water outlet nozzle cease to fit properly due to the fact that the seals have become worn or perished, replacement seals can be obtained from your KRUPS dealer. s The outlet nozzle seal is best removed from its seating with the aid of a suitable tool (e. g. Make sure that the new outlet nozzle seal is pressed firmly in place (11). The packaging consists entirely of environmentally-friendly materials, which should be passed on to the appropriate recycling agencies. [. . . ]