User manual KORG WAVESTATION

[. . . ] If something does slip into the equipment, unplug the AC adapter from the wall outlet. Then contact your nearest Korg dealer or the store where the equipment was purchased. CE mark which is attached to our company's products of AC mains operated apparatus until December 31, 1996 means it conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC). And, CE mark which is attached after January 1, 1997 means it conforms to EMC Directive (89/336/ EEC), CE mark Directive (93/68/EEC) and Low Voltage Directive (73/23/EEC). [. . . ] the indication of the value graph will change according to the pattern or tempo. Use /® buttons to select parameters, and use the Value dial and the ENTER/REC button to set the value of each parameter. If you select "CHAIN" as the rhythm pattern, there will be more chain pattern settings. You can also set the tempo by pressing the TAP button twice at the desired rhythm. If you select "JAM" as the recording mode in Phrase Trainer mode, the rhythm will sound with the pattern and tempo that you specify here. The settings you select here are remembered even when the power is turned off. Here you can switch the bass on/off, and specify the key in which the bass will play. If you press the ENTER/REC button in this screen, the bass will play in time with the rhythm. Depending on the rhythm pattern that you have selected, some bass lines will include a chord progression. When the bass note is on, you can use the Value dial to set the key in a range of C, C . A , B, allowing you to practice your guitar or bass in a scale that matches that key. The fifteen types BTQ CLN­FUZZ are guitar amps, and the ten types VALVE­UKMAJOR are bass amps. Low range* High range* On, Off Mid range* Type selection * Operation will be different if SYNTH is selected as the type. The value display will indicate "Gt" for approximately one second if you've selected a guitar model, or "bA" if you've selected a bass model. The amp type selected by the amp modeling selector can be selected and edited even without entering Edit mode. When you use the Amp Modeling selector to select an amp, the PX4D will automatically select the most appropriate cabinet model and turn it on. The VOLUME control knob can be used to adjust the VOLUME even when the amp modeling effect is "OFF. The value display will indicate "Gt" for approximately one second if you've selected a guitar amp cabinet, or "bA" if you've selected a bass amp cabinet. You are free to use a guitar AMP with a bass CAB, or a bass AMP with a guitar CAB. , when using headphones, or when connecting to a mixer, hard-disk recorder, or audio device). The eleven types 1X8TWD­4X12VIN are guitar amp cabinets, and the twelve types LA 4X10­COMBI are bass amp cabinets. These are spatial-type effects for which you can set the delay time by the interval at which you press the TAP button. [. . . ] This model simulates an American open back cabinet with two 10-inch speakers for guitar. This simulates an open back cabinet with four 10-inch speakers for guitar. This model simulates an open back cabinet with one 12-inch speaker for guitar typically used for blues. This model simulates a Vox open back cabinet with one 12inch "Blue" speaker for guitar. [. . . ]