User manual KORG POLY-800II

[. . . ] And Canada) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Unplug this apparatus during lightning storms or when unused for long periods of time. Turning off the power switch does not completely isolate this product from the power line so remove the plug from the socket if not using it for extended periods of time. Install this product near the wall socket and keep the power plug easily accessible. [. . . ] To select the master effect, press the MASTER button of the ZERO FX section to access the master effect page. This is a eight-pad type effect program page that you can control by pressing the eight pads shown in the touch area in the lower part of the page. By pressing the desired Beat setting of the LOOP DELAY effect, you can instantly switch the delay time's beat value. In touch effect pages 2­4, you can turn the HOLD button on (LED lit) to maintain the current state of the effect. When you take your finger off the touch pad, the effect will remain in the state in which you had last been touching the pad. When you take your finger off the touch pad, the effect sound will be completely "dry. This is a touch-pad type effect program page in which the entire page is a touch area. Different effect parameters can be assigned to the X-axis and Yaxis, allowing you to control two parameters simultaneously with a single operation. For touch effect types 1­4, you can use the knobs to perform the following operations. Knob 1: Selects the effect program Knob 4: Selects the effect channel when using a channel effect Knobs 5­8: Edit the effect parameters (the parameters that can be edited will depend on the effect program) For knob control effect type 5, you can use the knobs to perform the following operations. Knob 1: Selects the effect program Knob 2: Selects the effect channel when using a channel effect Knobs 3­8: Edit the effect parameters (the parameters that can be edited will depend on the effect program) This is an effect program page that does not use touch pad operations. By starting up the POLY-800II in the special 192 kHz audio mode, you can use it as a high-quality 24-bit/192 kHz 8-in/8-out audio interface. Note: When using Mac OS X, the 192 kHz sampling rate is not supported. Note: If you start up in 192 kHz audio mode, you won't be able to switch to other sampling rates (44. If you want to switch to a different sampling rate, you must turn off the power and then turn the power on again to start up in the normal way. The specifications are limited as follows when operating in the special 192 kHz mode. A MIDI device connected to the POLY-800II's MIDI IN/OUT connectors can communicate with your computer via the FireWire connector. " This chart makes it easy to determines the types of MIDI messages that each device is able to transmit or receive. When using two MIDI devices, you can compare their MIDI implementation charts to see whether the messages transmitted by one device will be recognized by the other device. Note: Details of the MIDI functionality are provided in the MIDI implementation, which can be found on the included CDROM. Note: When you connect the POLY-800II to your computer via a FireWire cable, it will be detected as a "3-in/3-out" MIDI interface. In this connection, "ZERO 1" is used to communicate between the POLY-800II and the included "ZERO Edit" editor software. [. . . ] It may be impossible to perform the installation successfully if other programs are running. Did you connect or disconnect the FireWire (IEEE 1394) cable or turn the POLY-800II's power on/off while the software was running?Exit all of your software; then turn the POLY-800II's power off and on once again. For some models of computer, starting up your computer with the POLY-800II already connected may cause operation to be unstable. [. . . ]