User manual KORG PANDORA PX2

[. . . ] Then contact your nearest Korg dealer or the store where the equipment was purchased. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The L/M buttons will select programs, and other buttons and the Value dial will not function. To enter Rhythm & Bass mode, press the RHYTHM button once when in Play mode (except for mute/bypass or key lock), AUX Pitch mode, or Phrase Trainer mode. When you enter this mode, the Rhythm Pattern selection screen will appear, the selected rhythm will start, and the Rhythm & Bass mode icon will light. the indication of the value graph will change according to the pattern or tempo. Use /® to select parameters, and use the Value dial and the ENTER/REC button to set the value of each parameter. If you select "CHAIN" as the rhythm pattern, there will be more chain pattern settings. You can also set the tempo by pressing the TAP button twice at the desired rhythm. If you select "JAM" as the recording mode in Phrase Trainer mode, the rhythm will sound with the pattern and tempo that you specify here. The settings you select here are remembered even when the power is turned off. Here you can switch the bass on/off, and specify the key in which the bass will play. If you press the ENTER/REC button in this screen, the bass will play in time with the rhythm. Effects that are turned "OFF" will automatically be turned on if you press the ENTER/REC button or use the L/M buttons to select the effect type. Renaming the program, infrared transmitter settings, and writing the program are also performed here. The amp type selected by the amp modeling selector can be selected and edited even without entering Edit mode. The VOLUME control knob can be used to adjust the VOLUME even when the amp modeling effect is "OFF. , when using headphones, or when connecting to a mixer, hard-disk recorder, or audio device). These are spatial-type effects for which you can set the delay time by the interval at which you press the TAP button. If the NR value is raised excessively, the sound may be cut off prematurely, depending on the device that is connected. Use the Value dial to adjust the depth of the noise reduction that is applied. The following characters can be used: space, 0­ 9, A­Z, ", `, , +, -, /. Normally you will adjust this so that you do not hear obtrusive noise when the strings are lightly muted. Select the character Select the character location Use the ENTER/REC button to turn the infrared transmitter on/off. [. . . ] This model simulates an American open back cabinet with one 12-inch speaker and a bright tonal character. This model simulates a Vox open back cabinet with one 12-inch "Blue" speaker. This model simulates an American open back cabinet with two 12-inch speakers. This model simulates a Vox open back cabinet with two 12-inch "Blue" speakers. [. . . ]