User manual KORG NANOPAD

[. . . ] On the Y-axis, values will be greater at the bottom and smaller at the top. Setup Operating requirements Mac OS X Computer Apple Macintosh computer with an Intel or PowerPC processor that has a USB port and satisfies the requirements for running Mac OS X Mac OS X 10. 3. 9, or Mac OS X 10. 4. 7 or later Global These are global parameters that make overall settings for the entire nanoPAD. These settings apply to all scenes 1­4. Parts and their functions 8 5 1 TOM 1 Global MIDI Channel [1. . . 16] Set this to match the MIDI channel of the application you're controlling. 2 TOM 1 TOM 1 Touch / Release This function transmits control change messages when you touch your finger to the X-Y pad and when you take your finger off the pad. [. . . ] Even if you don't need to use the nanoPAD with multiple applications simultaneously, we recommend that you install the Korg USB-MIDI driver for more stable operation. You can download the Korg USB-MIDI driver from the Korg website, and install it as described in the included documentation. (URL= http://www. korg. com/) If you want to use the Korg Kontrol Editor, you'll need to install the Korg USB-MIDI driver. MIDI Channel [1. . . 16/Global MIDI Channel] This specifies the MIDI channel of the MIDI messages transmitted when you strike the trigger pad. If you set this to "Global MIDI Channel, " the messages will be transmitted on the global MIDI channel. Restoring the factory settings If you turn on the power while holding down the [HOLD] button, [FLAM] button, and [SCENE] button, the settings of the nanoPAD will return to their factory-set condition, and the scene LEDs will light. The process of restoring the factory settings will take several seconds after you turn on the power. You must not turn off the power during this time. X-Y pad operations X-axis Y-axis Controls the speed of the roll. Moving toward the left edge of the X-Y pad will slow down the roll, and moving toward the right edge will speed up the roll. Moving toward the bottom edge of the X-Y pad will decrease the velocity values, and moving toward the top edge will increase the velocity values. Assign Type [No Assign/Note/Control Change] This specifies the type of message that will be assigned to the trigger pad. You can disable the pad (no assignment), or assign a note message or a control change. 4. [FLAM] button Press this to turn the Flam function on/off. Pad Behavior [Momentary/Toggle] You can choose one of the following two types of behavior for the trigger pad. Momentary The Note On or On Value will be transmitted when you press the trigger pad, and the Note Off or Off Value will be transmitted when you release it. Toggle The Note On or On Value will be transmitted alternately with the Note Off or Off Value each time you press the trigger pad. Troubleshooting Power does not turn on - If you're using a passive (non-powered) USB hub, the nanoPAD may fail to power-on because it is not getting enough power. [. . . ] Moving toward the left edge of the X-Y pad will decrease the velocity of the second strike, and moving toward the right edge will increase the velocity of the second strike. Off Value [0. . . 127] This specifies the value of the message that is transmitted when the trigger pad turns off. You can set this only if the assign type is "Control Change. " Y-axis Roll/Flam Enable [Disable/Enable] MIDI IN port This is where MIDI messages from the nanoPAD's various controllers are received. [. . . ]