User manual KORG N264

[. . . ] Then contact your nearest Korg dealer or the store where the equipment was purchased. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The calibration setting you make will be valid until the power is turned off. Once the power is turned off, calibration will be reset to A = 440 Hz. In Play mode, hold down the EXIT button and press either the button or the ® button to assign the following functions. By activating the Key Lock function, you can disable all operations except for selecting programs. This is a convenient way to prevent accidental operation during a live performance. The L/M buttons will select programs, and other buttons and the Value dial will not function. If you want to change the function of the Value dial so that it will adjust the master level, hold down the EXIT button once again and press the button, or turn on the power once again. To enter Rhythm mode, press the RHYTHM button once when in Play mode (except for mute/ bypass or key lock), AUX Pitch mode, or Phrase Trainer mode. When you enter this mode, the Rhythm Pattern selection screen will appear, the selected rhythm will start, and the Rhythm mode icon will light. the indication of the value graph will change according to the pattern or tempo. Use /® to select parameters, and use the Value dial and the TAP button to set the value of each parameter. AUX Records only the AUX input BASS Records only the bass sound AUX+BAS Records both the AUX input and bass JAM Records the bass together with the rhythm that was last selected in Rhythm mode Use the value dial to select the recording time (for "JAM, " the number of measures). Start playback on your CD or other audio source, and at the point where you wish to begin recording, press the ENTER/REC button. If, after recording, you want to change the recording mode or recording time, press the PHRASE TRAINER button while playback is paused. During playback or while paused, you can use the L/M buttons to select programs. If you do not stop recording, recording will continue until the selected recording time has elapsed, and loop playback will begin automatically. Each time you press an /® buttons, you will cycle through the effects in the order shown below. For each effect, you can select the effect type and set its parameter values. Effects that are turned "FX OFF" will automatically be turned on if you press the ENTER/REC button or use the L/M buttons to select the effect type. Renaming the program, infrared transmitter settings, and writing the program are also performed here. The VOLUME control knob can be used to adjust the VOLUME even when the amp modeling effect is "FX OFF. " The amp type selected by the Amp Modeling selector can be selected and edited even without entering Edit mode. [. . . ] (recommended CAB: CLS8X10) BASS ---------------- low range A vacuum tube amp whose basic character changes according MIDDLE ------------ mid range to the setting of the value dial. 5) (recommended CAB: LA 4X10, LA 1X18) An amp distinctive for its eye-catching gold panel and clean sound. BASS ---------------- low range (recommended CAB: STU1X15) MIDDLE ------------- mid range A 100W vacuum tube amp made by Vox. Adjusts the sensitivity of the synth in response to the volume of the bass Adjust this as appropriate for your bass or pickup. [. . . ]