User manual KORG MINI POPS 120

[. . . ] Please connect the designated AC adapter to an AC outlet having the correct voltage. Do not connect it to an AC outlet having a voltage other than that specified for your unit. CE mark which is attached to our company's products of AC mains operated apparatus until December 31, 1996 means it conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC). And, CE mark which is attached after January 1, 1997 means it conforms to EMC Directive (89/336/ EEC), CE mark Directive (93/68/EEC) and Low Voltage Directive (73/23/EEC). [. . . ] Also, CE mark which is attached to our company's products of Battery operated apparatus means it conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC). Keeping foreign matter out of your equipment Never set any container with liquid in it near this equipment. If liquid gets into the equipment, it could cause a breakdown, fire, or electrical shock. If something does slip into the equipment, unplug the AC adapter from the wall outlet. Then contact your nearest Korg dealer or the store where the equipment was purchased. Are the trademarks or registered trademarks of their respective owners. This product has been manufactured according to strict specifications and voltage requirements that are applicable in the country in which it is intended that this product should be used. If you have purchased this product via the internet, through mail order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside. WARNING: Use of this product in any country other than that for which it is intended could be dangerous and could invalidate the manufacturer's or distributor's warranty. Please also retain your receipt as proof of purchase otherwise your product may be disqualified from the manufacturer's or distributor's warranty. If you want to store the Hold state, press the HOLD button to turn it on. The position at which you last touched the pad will be stored as the held position on the touch pad. Hold down the MEMORY B button and press the TAP button, and then use the PROG/VALUE knob to select "r. Hit the TAP button several times in tempo with your song, and the mini-KP will detect the corresponding BPM value and use it as the current setting. While the BPM value is displayed, you can also adjust the BPM value by turning the PROG/VALUE knob. If you hold down the TAP button for an extended time, the mini-KP will switch from the BPM setting back to program selection. The mini-KP will also return to the program selection state if you haven't performed any setting operation for five seconds. To return to the normal play mode, once again hold down the MEMORY B button and press the TAP button. The mini-KP will also return to the normal play mode (program selection state) after about three seconds if no additional setting operations are performed. With FX RELEASE, the moment you take your hand off the touch pad, a delay effect synchronized to the current BPM will be applied, and will then gradually diminish. [. . . ] With FX RELEASE, the moment you take your hand off the touch pad, a delay effect synchronized to the current BPM will be applied, and will then gradually diminish. This allows you to make smoother transitions and avoid the abrupt change from a hard-edge effect back to the original --and unaffected-- signal. Hold down the TAP button and the MEMORY A button as you turn on the power; all settings will return to their factory-set state. LINE IN jacks (RCA phono jacks) LINE OUT jacks (RCA phono jacks) HEADPHONES jack (Stereo 1/ 8" mini phone jack) Power supply: four alkaline AA (LR6) batteries (6 V) Battery life: approximately five hours (with alkaline batteries) Dimensions: 106 mm (W) x 129 mm (D) x 29 mm (H) / 4. [. . . ]