User manual KORG KPC1

[. . . ] A mic effect to simulate using an acoustic guitar with a condenser microphone 17 effects including 3- Pre effects: Compressor, Limiter, Exciter, plus 11 Ambience effects, Chorus, Notch Filter, and Noise Reduction 80 Programs: 40 presets and 40 user 2 effects can be used simultaneously in addition to Body models /Mic effect, plus Noise Reduction Knob interface for quick and easy operation Program select foot switches Expression pedal for realtime control Built in auto-chromatic tuner w/mute function Headphone connector Battery or AC-powered AX10-Series EasyStart NOTE: The following procedures work for all 3 of the AX10-series effect units!If connecting headphones or powered monitors, select "LINE" with the LINE/AMP switch on the rear panel. [. . . ] If using headphones, mixer, or amplifier, connect to the OUTPUT jack on the rear panel. After making audio output and AC connections, connect your guitar to the INPUT jack on the rear panel. Step on the program select switches simultaneously, to activate bypass mode, and the auto- chromatic tuner will be active. To return to the previous mode, step on either of the select switches again. Restoring the Factory Preset Programs 1. When loading is complete, the display will blink, and then program number 0. 1 will appear. Note: If you reload the preset programs, all previously stored programs will be overwritten. To assign the Effects to the Expression pedal, press the FX/BANK HOLD button. Each time you press this button, the LED will change color to indicate the specific pedal Effect that will be controlled. -WAH (orange): Pedal Wah (AX10G and AX10B) (Note: For KPC1, this setting allows you to eliminate feedback by position of the pedal) -MOD (red): The Effect selected by Modulation -AMB (green): The Effect selected by AMBIENCE -VOLUME (unlit): Volume Pedal 7. Using the Pedal to switch the Effects on and off: By advancing the Pedal all the way forward you can switch the selected PEDAL FX Effect on/off. If VOLUME is selected as the PEDAL FX, the LED cannot be turned off. Saving a Program You've tweaked and turned some knobs, and you like the changes that you've made ­ now to save your program: 1. Press the WRITE button, The Program number will blink in the display, and the AX10 will be in "write ready" mode. [. . . ] Press the WRITE button, The Program number will blink in the display, and the AX10 will be in "write ready" mode. Use the Program Select switches to select where you would like to store the program. [. . . ]