User manual KORG KEYBOARD ASSEMBLY 61KEY

[. . . ] do not use liquid cleaners such as benzene or thinner , or cleaning compounds or flammable polishes. Keep this manual After reading this manual, please keep it for later reference. Keeping foreign matter out of your equipment Never set any container with liquid in it near this equipment. If liquid gets into the equipment, it could cause a breakdown, fire, or electrical shock. [. . . ] In addition, the module section may be completely removed and operated as an independent tone module, or used with other KKS products for further convenience. Please observe the following cautions in order to ensure safe and correct assembly and disassembly. Perform the steps in the correct order, making sure that each part is oriented correctly. Be careful not to pinch your hand while raising or lowering the module. Be sure that the module is powered-off when you connect or disconnect the cable between the keyboard assembly and the module. If you connect or disconnect this cable while the power is on, the module may stop operating correctly. Before you proceed, be sure to read and follow the "Safety precautions" found earlier in this manual. By touching or rubbing your finger on this ribbon you can control various program and effect parameters on the connected module. Don't tilt the module too far, since this will subject the keyboard assembly to excessive strain. By moving the joystick up/down/left/right you can control various program and effect parameters on the connected module. You can use these switches to control various program or effect parameters on the connected module, or to turn the joystick or ribbon controller's Lock function on/off. One end of the connecting cable (8) will plug into this jack, and the other end will plug into the module's TO KYBD port. When connected, you'll be able to use the keyboard assembly's keyboard, joystick, ribbon controller and switches to control the module. Each locking support "B" that had been used to attach the module to the keyboard assembly in step 1. While supporting the module with one hand, fold in each of the locking supports "B" , and fold out the tab portion that had been inside. Be careful not to pinch your hand between locking supports "B" and the module. Slowly lower the module onto the locking supports "B, " Ensuring that the screw hole of each locking support "B" is aligned with the screw holes on the rear of the module. At this time, the protrusion of each locking support "B" will fit into a notch on the bottom of the module, helping to hold the module in place as you perform the next step. Be careful not to pinch your hand between locking supports "B" and the module. If you move the keyboard assembly or apply excessive force to the module before you've fastened the module in place with the screws, the module may fall down, causing injury. [. . . ] While using one hand to raise the module, connect the The included cable is only for the purpose of connecting the TO KYBD connector with the TO MODULE connector. Position shown in the illustration below, and fasten the module to the keyboard assembly using the two screws you removed in step 1 of "Removing the module. This product has been manufactured according to strict specifications and voltage requirements that are applicable in the country in which it is intended that this product should be used. If you have purchased this product via the internet, through mail order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside. [. . . ]