User manual KORG IS4

[. . . ] Power supply Please connect the designated AC adapter to an AC outlet of the correct voltage. Do not connect it to an AC outlet of voltage other than that for which your unit is intended. handling To avoid breakage , do not apply excessive force to the switches or controls. do not use liquid cleaners such as benzene or thinner , or cleaning compounds or flammable polishes. [. . . ] Pressed a first time it selects Bank 2; pressed a second time it selects Bank 3; pressed a third time it selects Bank 1 again. (#) These columns show the number of oscillators per voice used by each sound You can play two sounds at the same time on the keyboard. Note: When selecting the Layer mode, the total number of voices that can play at the same time is reduced, depending on the total number of oscillators used by the selected sounds. Note: You can't select two sounds included under the same button. Press one of the sound selection buttons in order to select the first sound. Note: Steps 1 and 2 are not required, if the right banks are already selected. To return to the Single mode, just press a single Adjust the balance between the sounds in Layer mode, hold down the button of the sound whose level you wish to decrease, and repeatedly press the button of the sound whose level you wish to raise. Note: This setting will be memorized even after turning the Layer mode off, but will be lost when turning the instrument off. To save these settings, save them using the Data Dump function (see "MIDI Data Dump" on page 30). The reverb simulates the sound reverberation in a room, while the chorus simulates a modulating effect that makes the sounds richer. The effect settings will be remembered even when selecting a different sound. To select one of the available temperaments, hold down the TOUCH button, then press the button corresponding to the desired temperament. To return to the equal tuning hold down the TOUCH button, then press the sound selection button whose LED is lit. This is the Werckmeister III scale invented by Andreas Werckmeister, the German organist and music theoretician. This scale was created in the later Baroque period to allow relatively free transposition. This is the Kirnberger III scale invented by Johann Phillip Kirnberger in the early 18th century, and is used mainly for tuning harpsichords. This temperament spaces all semitones at equal distances, and allows identical scales to be played in any key. Both LEDs turned off To check the currently selected temperament, hold down the TOUCH button, and look at which of the above LEDs is turned on. Note: When the power is turned on, the equal temperament will be automatically selected. 1 and PIANO 2 sounds use a "stretched tuning" that makes the notes of the lower range slightly flatter than equal temperament, and the upper range slightly sharper. This is how an acoustic piano is normally tuned by professional tuners. It is an international standard that was created to connect and transfer data between electronic musical instruments, computers and other devices. [. . . ] When the data dump is completed, you will return to normal playing condition. You may cancel a data dump operation before the data dump begins, by pressing the TRANSPOSE/FUNCTION or VIBES/GUITAR button. You can load into the SP-300 data you previ- On the SP-300, hold down the TRANSPOSE/FUNCTION button and press the VIBES/GUITAR sound selection button. Set the data filer to send the sound setting data that were previously saved from the SP-300. [. . . ]