User manual KORG GT120 2

[. . . ] Play a single note on your instrument, and tune it so that the needle of the meter is at the 0 position (center) and both indicators of the tuning guide are lit. While tuning, do not allow extraneous sounds to enter the mic. AUTO : Meter mode (Auto) MANUAL : Meter mode (manual) SOUND : Sound mode (manual) Adjusting the zero point of the meter needle If the GT­120 is jarred while being transported etc. , or due to normal aging after extended use, the VU style meter may drift away from the 0 position (center). [. . . ] In steps 5 and 6, place your instrument as close as possible to the built-in mic. (At the position, the power will be on, and in addition the display will be illuminated. ) When the power is turned on, the previously-selected reference pitch (default setting: A=440 Hz) will be selected, and the GT-120 will be in Meter mode (Auto) 3. If you wish to change the reference pitch (calibration), press the [CALIB] switch. Rotate the [TUNING TYPE] dial to select the appropriate instrument or set to CHROMATIC. ( ): Default values for MANUAL CHROMATIC : C, C , D, E , E, F, F , G, G , A, B , B (A, sound output: A4) GUITAR : 6E, 5A, 4D, 3G, 2B, 1E (6E) OPEN D : 6D, 5A, 4D, 3F , 2A, 1D (6D) OPEN E : 6E, 5B, 4E, 3G , 2B, 1E (6E) OPEN G : 6D, 5G, 4D, 3G, 2B, 1D (6D) OPEN A : 6E, 5A, 4E, 3A, 2C , 1E (6E) DADGAD : 6D, 5A, 4D, 3G, 2A, 1D (6D) BASS : LB, 4E, 3A, 2D, 1G, HC (LB) LB: Low B, HC: High C 5. When using AUTO Play a single note on your instrument, and the name of the nearest note will appear in the LCD display. Tune your instrument so that the correct note name is shown in the LCD display. When using MANUAL Press the [NOTE] switch until the note you wish to tune (C­B) appears in the LCD display. · Each time you press the [AUTO/MANUAL] switch, the setting will switch between AUTO and MANUAL. Handling To avoid breakage, do not apply excessive force to the switches or controls. Care If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use liquid cleaners such as benzene or thinner, or cleaning compounds or flammable polishes. Flat tuning When the [TUNING TYPE] dial is set to GUITAR or BASS, you can use Meter mode or Sound mode to tune to a pitch that is lowered by 1­4 ) for the specified note. As described in "Meter mode" or "Sound mode, " make the note you wish to flatten by 1­4 semitones appear in the LCD display. Press the [FLAT] switch to select the number of semitones that you wish to lower the selected note. Tune your instrument. Keep this manual After reading this manual, please keep it for later reference. Keeping foreign matter out of your equipment · Never set any container with liquid in it near this equipment. If liquid gets into the equipment, it could cause a breakdown, fire, or electrical shock. [. . . ] The VU style meter may drift from the 0 position (center) when the OT­120 is tilted. If this occurs, perform the procedure described in "Adjusting the zero point of the VU style meter" while the unit is tilted, so that the VU style meter points to 0. 1. [. . . ]