User manual KORG D4 DIGITAL RECORDER

[. . . ] Owner's Manual E 1 Precautions Location Using the unit in the following locations can result in a malfunction. · In direct sunlight · Locations of extreme temperature or humidity · Excessively dusty or dirty locations · Locations of excessive vibration · Close to magnetic fields THE FCC REGULATION WARNING (for U. S. A. ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] You can also press the [PLAY] key to audition the playback for approximately two seconds starting at the selected time. Modifying the time here will not affect the time that is registered in the key. Press the [OUT (LOC2)] key to return to the previous step. DestTrk Blank 9 Specify the "ToTime. " Use the [VALUE] dial to select one of the choices. Then press the CURSOR [ ] key. You can press the [PUNCH] key at this point to modify the selected time. You can also press the [PLAY] key to audition the playback for approximately two seconds starting at the selected time. Press the [PUNCH] key to return to the previous step. 46 As an example, here's how to insert a blank space into the In­Out region of track 1. 1 Store the In and Out time locations in the [IN (LOC1)] key and [OUT (LOC2)] key. Set the [MODE] knob to "TRK EDIT. " 3 Select the Insert operation. Use the [VALUE] dial to select "InsTrack, " and press the CURSOR [ ] key. 4 Select "InsertTo" (track number into which you want to insert a blank space). Use the [VALUE] dial to select the number of the track into which you want to insert a blank space. For this Operation example, select "1. " Then press the CURSOR [ ] key. 5 Set the "In Time" and "Out Time. " Use the [VALUE] dial to specify each locate point. After you've specified the locate points, press the CURSOR [ ] key. (Refer to "Copying a track") You can press the [PLAY] key to hear approximately two seconds of playback starting at the selected time location. 6 Execute the editing operation. When the display asks "Ins OK?, " press the CURSOR [ ] key to execute the operation. When the blank space has been inserted, the display will indicate "Finish!" 7 Press the [PLAY] key to listen to the play back, and verify that the operation occurred as you intended. You can press the [UNDO] key to return to the state prior to executing this operation. Use the [VALUE] dial to select "ErsTrack, " and press the CURSOR [ ] key. 4 Select "EraseTo" (track number from which you want to erase data). Use the [VALUE] dial to select the number of the track from which you want to erase data. For this example, select "1. " Then press the CURSOR [ ] key. Use the [VALUE] dial to make your selections (see "Copy Track"). [. . . ] If a card is already inserted, turn off the power, re-insert the card, and then turn the power back on. To-End. 5 When executing "ExpTrack, " the ToTime and EndTime are set (relative to the InTime-OutTime) to settings that cannot be executed (i. e. , compression to less than 50%). Re-set the time settings to appropriate values. NoLength When executing a track editing operation, the InTime and OutTime (or ToTime and EndTime) were set to the same time location. Set each time correctly. To-Endx2 When executing "ExpTrack, " the ToTime and EndTime are set (relative to the InTime-OutTime) to settings that cannot be executed (i. e. , expansion to greater than 200%). Re-set the time settings to appropriate values. RecSave? Do you want to save the recording as long as there is space on the card? [. . . ]