User manual KORG CX3

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. € Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] The WAVEDRUM Mini will continue functioning for a time, but you should replace the batteries as soon as possible. You should also remove the batteries if you won't be using the unit for an extended period of time. If the clip is left attached to an object for an extended period of time, it may leave a mark on the object when removed. Depending on aging or the state of the object's surface finish, damage may occur regardless of the length of time. If you're performing in a seated position, you can use the included strap to fasten it to your leg. When using the clip, fasten it securely to the object, ensuring that it's in a stable location like the WAVEDRUM Mini itself. You should neatly bundle the power cable and audio cable so that they don't catch on anything. Again, although there will be differences between users, striking the surface with the pad of your fingertip as though you were pressing it will produce a softer sound, while slapping the surface with all your fingers will tend to produce a harder sound. The open and slap performance techniques used on a conga or djembe will produce similar tonal changes. For the clip, you can try attaching it to different materials, and enjoy the resulting differences in strike responses and tonal changes. For details on the sounds, refer to “Sounds” (See page 68). You can repeat the above steps to overdub your performance as many times as you wish. Note: If you want to erase your recorded performance and re-record, you can use the Undo/Redo function. Note: If you press the button from the stopped condition, playback and recording will start simultaneously. Playing and overdubbing rhythm patterns You can enjoy jamming along with rhythm patterns in a variety of genres. While holding down the SHIFT button, press the button to make the rhythm pattern / looper select indication (located in the upper right of the operating panel) light up. If you hold down the SHIFT button and press the + button, the previous rhythm pattern will be selected. The recorded performance will disappear when you select another rhythm pattern, switch to the Looper function, or turn off the power. Immediately after the power is turned on, the original rhythm pattern 00 will be selected. During playback and recording, the pad sensitivity will automatically be lowered to prevent acoustic feedback. If you mute the rhythm pattern, you'll hear only the performance that you overdubbed. Note: If you select another rhythm pattern (or switch to the Looper) while muted, muting will automatically be cancelled. [. . . ] When you execute this operation, the WAVEDRUM Mini will be returned to its factory-set condition, and will be in the same state as after a normal power-on. No sound from the speaker • Turn the VOLUME knob toward the right. € No sound will be output from the speaker if a cable is connected to the headphone jack or the OUTPUT jack. Error messages The WAVEDRUM Mini automatically performs an internal check when its power is turned on. [. . . ]