User manual KORG CA40

[. . . ] When the batteries run low, a battery indicator will appear in the left of the display. When this indicator appears, replace the batteries as soon as possible. [. . . ] Sound Out mode This mode lets you listen to a reference tone while you tune your instrument. The CA-40 will be in Sound Out mode, and the speaker will play a reference tone. Hold down the [SOUND/NOTE SELECT] button, and use the CALIB [ ] [ ] buttons to change the pitch of the reference tone that is audible from the speaker. Handling To avoid breakage, do not apply excessive force to the switches or controls. do not use liquid cleaners such as benzene or thinner , or cleaning compounds or flammable polishes. Using the tuner Tuning guide [STANDBY/ON] button CALIB[ ], [ ] buttons Display Speaker Keep this manual After reading this manual, please keep it for later reference. Keeping foreign matter out of your equipment Never set any container with liquid in it near this equipment. If liquid gets into the equipment, it could cause a breakdown, fire, or electrical shock. ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. €¢ Increase the separation between the equipment and receiver. [. . . ] CE mark for European Harmonized Standards CE mark which is attached to our company’s products of AC mains operated apparatus until December 31, 1996 means it conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC). And, CE mark which is attached after January 1, 1997 means it conforms to EMC Directive (89/336/EEC), CE mark Directive (93/68/EEC) and Low Voltage Directive (73/23/EEC). [. . . ]