User manual KORG BEATLAB

[. . . ] Handling To avoid breakage, do not apply excessive force to the switches or controls. Precautions Location Using the unit in the following locations can result in a malfunction. €¢ In direct sunlight • Locations of extreme temperature or humidity • Excessively dusty or dirty locations • Locations of excessive vibration • Close to magnetic fields Care If the exterior becomes dirty, wipe it with a clean, dry cloth. do not use liquid cleaners such as benzene or thinner , or cleaning compounds or flammable polishes. [. . . ] If not, press the TAP key twice or more to specify the intermediate time as the tempo. When the program pauses, replay starts immediately after you specify a tempo using the 10 TAP key . €œEDIT” appears on the LC display when the setting is changed. Specifying the rhythm note volumes Use the GROUP NOTES key and the sliders to adjust the rhythm note volumes. €œEDIT” appears on the LC display when the setting is changed. <Operate the following sliders without pressing the GROUP NOTE key> Operate the ACC/5 slider to adjust the accent note volume. <Operate the following sliders while pressing the GROUP NOTE key> Operate the ACC/5 slider to adjust the quintuplet note volume. note: The BEATLAB is designed to provide a high output for the headphone volume. When using a headphone, set the volume to zero first, then gradually increase it for adjustment. 11 Saving the program parameters (WRITE) You can save the settings of the program parameters in the BEATLAB memory. If selecting other program or moving to another mode before saving the current parameter setting, the chain setting will be returned to the previous one. Be sure to save your important programs in the memory by carrying out the writing operation. The BEATLAB goes to the program selection state, and the program number blinks s on the display. (2) Enter the program number where the settings are to be saved using the and keys or the numeric keys. Note: Once the writing operation is executed, the program currently saved in the selected program number is overwritten. To cancel the writing operation, press either the parameter selection key or the mode key. The parameters are saved and “EDIT” disappears from the display. In the chain mode, you can continuously replay one program after another, which has been saved in the program mode. - The BEATLAB offers eight chains, each of which consists of one TEMPO and up to 16 BARS. 12 Chain configuration TEMPO PRG 1 PROGRAM 5 TEMPO CHAIN 2 140 1 PROGRAM 10 CHAIN 1 •••• •••• 2 5 2 11 3 6 3 -•••• BAR 4 6 BAR 4 5 7 5 ••• ••• 16 6 16 ••• ••• the end command, the BEATLAB returns to bar 1 after replaying bar 2, resulting in alternative replay of bars 1 and 2. - You can specify a tempo to the entire chain, in which case the programs are all replayed in the tempo you specify. Otherwise you can replay the individual programs in the tempos specified to them. [. . . ] € (2) Enter the tempo using the and keys or the numeric keys. If not, press the TAP key twice or more to specify the intermediate time as the tempo. When the training pattern pauses, replay of the training pattern starts immediately after a tempo is specified. Selecting the hand to start beating on the training pattern - To start beating by the right hand, press the parameter selection key under the green LED. [. . . ]