User manual KORG AX30G

[. . . ] You can also press this key once and adjust the BPM with the PROGRAM/BPM knob. HOLD ­ Pressing this key with hold the last state of the X-Y Pad and any SAMPLE key that is pressed. SAMPLE 1/SAMPLE 2 ­ Pressing either of these keys will playback the sample that was recorded using the REC/STOP key. [. . . ] REC/STOP ­ Use this key to record samples to the SAMPLE 1/SAMPLE 2 keys. INPUT VOLUME ­ This knob sets the level of the input signal that is fed to the effect. PROGRAM/BPM­ Use this knob to select different effect programs and to set the BPM. FX DEPTH ­ This knob controls the wet/dry amount of effect and on programs 50-84 it controls the overall volume. PHONES VOLUME ­ This knob controls the level of volume for the ¼" headphone jack. MIC TRIM ­ This knob sets the level for the ¼" microphone input. MIC/PHONO/LINE ­ This switch selects the input source for the KP-2. PAD MOTION/MUTE - Pushing this lever up triggers the PAD MOTION function, pushing it down mutes the input signal. Connecting the KP-2 1. 3. To record a pad move, push up and hold the PAD MOTION / MUTE lever. Recording will end once you release the lever or reach the maximum recording time (approximately 3. 2 seconds). This means you can record yourself tapping on the pad as well, as long as you hold the lever up while tapping. To playback what was recorded, push and hold the PAD MOTION / MUTE lever. The recorded moves will playback in a loop as long as the lever is held. If you touch the X-Y pad while playing back a PAD MOTION you will erase it and start recording again. Also, PAD MOTION moves are lost when you select a new program. ! Using the Mute Function 1. To mute the input and hear the effect tail push down on the PAD MOTION / MUTE lever. You can also toggle the lever up and down to create "transformer" type effects. 3 KP-2 EasyStart Using the Auto BPM Detect Function 1. To enable the KP-2 Auto BPM Detect function when you have selected one of the "BPM FX/PTN" programs, press and hold down the TAP/BPM key until three dots appear in the display. [. . . ] You can also toggle the lever up and down to create "transformer" type effects. 3 KP-2 EasyStart Using the Auto BPM Detect Function 1. To enable the KP-2 Auto BPM Detect function when you have selected one of the "BPM FX/PTN" programs, press and hold down the TAP/BPM key until three dots appear in the display. Typically music with a strong kick drum and backbeat pattern works best! 2. ! Using the Tap Tempo Function 1. To sync the BPM using the Tap Tempo function, press the TAP/BPM key two or more times in rhythm with the beat of the song. The BPM will appear in the display. Syncing to MIDI Clock 1. To sync the BPM to MIDI clock from an external MIDI device which is connected to the MIDI IN of the AX30G, press and hold down the TAP/BPM key and the REC/STOP key. [. . . ]