User manual KONTRON FIELDPAC PORTABLE ADD-IN COMPUTER

[. . . ] FieldPACTM Portable Add-in Computer Document Revision 1. 0 About this Product The FieldPAC is sold by Kontron America's Mobile Rugged Division (formerly Dolch Computer Systems. ) About This Manual This document provides information about the FieldPAC. While every attempt has been made to ensure that the information in this document is accurate, the information contained within is supplied "as-is" and can change without notice. Trademarks FieldPAC is a trademark of Kontron America's Mobile Rugged Division. All other product names are trademarks or registered trademarks of their respective holders. Copyright Notice Copyright © 2006 Kontron America's Mobile Rugged Division. No part of this manual may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means (electronic, mechanical, photocopying, recording, or otherwise), without the written permission of Kontron America's Mobile Rugged Division. Standards Kontron America's is certified to ISO 9001:2000 & AS9100:2004. Technical Support If you are unable to obtain proper use of your product, contact Kontron America's Mobile Rugged Division for technical support. [. . . ] Default: Enabled First/Second/Third Boot Device When enabled, this option determines which drive to search for first for the operating system such as DOS. Floppy (First) SCSI HDD-2 LS-120/Zip CD-ROM (Third) HDD-3 HDD-0 (Second) HDD-1 LAN 3. 12 3 !CONFIGURATION Boot Other Device This option allows the system to search for an operating system from devices other than the ones selected in the "First/Second/Third Boot Device" option. Default: Enabled Swap Floppy Drive This option either enables or disables the swap floppy drive function. When enabled, the BIOS swaps the floppy drive assignments so that Drive A becomes Drive B, and Drive B becomes Drive A. Default: Disabled Boot Up Floppy Seek When enabled, the BIOS will seek whether or not the floppy drive installed has 40 or 80 tracks. The 360K type has 40 tracks while 760K, 1. 2MB and 1. 44MB types all have 80 tracks. Default: Enabled Boot Up NumLock Status This option allows you to activate the NumLock function after you power up the system. Default: On Gate A20 Option This option determines how gate A20 is handled. Today, while keyboards still provide this support, it is more common and much faster, for the system chipset to provide support for Gate A20. Default: Fast Typematic Rate Setting When this option is disabled, holding down a key on your keyboard will generate only one key stroke at a time. When enabled, you can set the next two listed typematic control options. CONFIGURATION Typematic Rate (Characters Per Second) When this option is enabled, the system registers repeated keystroke speeds. Default: 6 Typematic Delay (Msec) When the "Typematic Rate" option has been enabled, this option will allow you to set the time interval for displaying the first and second characters. Default: 250 Security Option This option allows you to limit access to the "System" and to the "Setup" utility. When you select the "System" option, the system prompts for the "User Password" every time you boot up. When you select the "Setup" option, the system boots up and prompts for the "Supervisor Password" only when the "Setup" utility is called up. Default: Setup OS Select for DRAM > 64MB This option allows the system to access greater than 64MB of DRAM memory when running an OS/2 program. Default: Non-OS/2 Report No FDD for Win 95 IRQ6 is usually assigned to a floppy disk drive. If the drive does not exist, this option will allow Windows 95 to share it with other peripherals. Default: No Small Logo (EPA) Show This option can be set to enabled or disabled. CONFIGURATION Advanced Chipset Features Setup The following section describes how to configure your system based on specific features of the installed chipset. The chipset manages bus speeds and access to the system memory resources, such as Dynamic Random Access Memory (DRAM) and external cache. [. . . ] Turn "Off" and unplug the system before connecting a peripheral device. Users are advised to purchase the latest versions of virus protection software and use them regularly. Make sure the external power source, used with the FieldPAC, conforms to the AC power adapter and system ratings. Arrange all cables so they are out of the way of traffic, personnel and equipment. [. . . ]