User manual KONICA PAGESCOPE NETWORK SETUP V3.2

[. . . ] PageScope Network Setup 3. 2 User Manual Foreword Welcome Thank you for using KONICA MINOLTA PageScope Network Setup. PageScope Network Setup is utility software which allows simple network setup of devices such as printers. It allows setup of devices on networks connected using TCP/IP or IPX protocol to be handled together. · Allows a user to verify and change the network and print settings for devices. [. . . ] You can type up to 16 characters into the text box to input a new description. However, if an existing description of the device exceeds 16 characters, you can type up to 255 characters for a new description. · If both DHCP and BOOTP are selected, DHCP is given priority. 14 4 Changing the Device Setup 4. 3 NetWare Print Setup Note · You must have NetWare Client 32 installed on your system in order to setup for NetWare printing. · NetWare supervisor privileges are required in order to change the NetWare Print Setup. You must login to the NetWare network with supervisor privileges in order to configure NetWare for printing. · You must have IPX protocol installed on your device in order to configure a NetWare print setup. · If you have already configured a NetWare print setup with another tool, the existing configuration will be deleted when you complete this setting. Perform the following steps to configure a device for NetWare printing. On the device list, click the icon of the device you want to configure. Select Device Setup on the Setup menu to display the Device Setup dialog box. See 4. 3. 5 Verifying the Setup. Note · Clicking the NetWare Printing tab downloads the device configuration. Downloading can take anywhere from a few seconds to 20 or 30 seconds or more. Wait for the download procedure to complete before trying to do anything else. · The community name input dialog box appears only if the SNMP community name has been changed to something other than the default name. Type in the community name and then click OK. 15 4 Changing the Device Setup 4. 3. 1 Setting up the Print Server Perform the following steps to set up the print server for NetWare printing. Type up to 26 characters into the Print Server Name box for the print server name. If asterisks (*) appear in the print server name, non-ASCII characters have been used for naming the print server. Normally, you should leave the following items set to their initial defaults. Print Queue Scan Rate Type in the interval, in seconds, to specify how often the print server should check the queue. Ethernet Frame Type Specify the Ethernet frame type. 16 4 Changing the Device Setup 2. After you are finished configuring the setup, click the Next button. Note · To configure a NetWare print setup, the server must be bound to at least one IPX frame. 4. 3. 2 Selecting the Mode Use the procedures in this section to select the server you want to configure as the print server, or the NDS context. If you are using bindery service (NetWare 3. x): 1. Click the button to display the Mode Select dialog box, which shows a list of servers on the NetWare network. Select the server you want to configure as the print server, and then click the OK button. [. . . ] Add device manually: A device that cannot be automatically searched for can be displayed in the device list by entering its IP address. Type the IP address of the device you want to display into the IP Address box. If the entered IP address is accessed and there is a response, that IP address is added to the Add Device box. To remove an address appearing in the Add Device box, select it, and then click the Delete button. [. . . ]