User manual KOMPERNASS KH 4164 DESK LAMP

[. . . ] Read these operating instructions carefully before using the appliance for the first time and preserve this manual for later reference. Pass this manual on to whoever might acquire the appliance at a future date. In particular, do NOT use higher-performance bulbs or any without a protective disc. [. . . ] Should the appliance become damaged, immediately remove the plug from the wall socket. After use or during extended absences, ALWAYS remove the plug from the power socket. For as long as the plug is inserted in the wall socket the appliance itself is under electrical power. If you do, there is the risk of being injured on the housing edges, by splittering glass or being burnt on hot elements. This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. Children should be supervised to ensure that they do not play with the appliance. First put the components together completely before operating the lamp: · Turn the counterweight q onto the rear of the swivel-arm. Carefully pull the power cable w so far out of the lamp base until the swivel arm is flush in the lamp base. Place the suction disc r onto the front of the bulb and press it firmly. Guide the bulb into the bulb holder and secure it by turning it through a quarter-turn in a clockwise direction. Check to ensure that the appliance is undamaged, all component parts are present and that packaging remnants are removed from it. Do NOT operate the lamp with the suction disc fitted ­ it would be melted immediately by the heat. Always adjust the position of the lamp with the lever y, not with the lamp housing. You can adjust the swivel-arm in that you first loosen the locking device u. [. . . ] Do NOT operate the lamp with the suction disc fitted ­ it would be melted immediately by the heat. Do not use abrasive cleaners or detergents, these could damage the surfaces. Lämna in produkten till ett företag som har tillstånd att ta hand om den här sortens avfall eller till din kommunala avfallsanläggning. [. . . ]