User manual KOMPERNASS KH 3236 MULTI-DETECTOR

[. . . ] This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. Children should be supervised to ensure that they do not play with the appliance. Do NOT use the appliance to determine the alternating voltage level in exposed or non-insulated power cables. [. . . ] For this, use the spirit level: The bubble in the glass 8 must stand between the marking lines (see Fig. When you hold the button READ 6 pressed down and slowly move the appliance over the surface to be measured, the appliance continually measures the distances. Take note of the following illustrations: The further you are from the wall, the wider is the area (a) that the MultiMeasurement Detector must measure by ultrasound (Fig. Therefore take care that the Manifold Measurer is always directed at a right angle towards a level surface (Fig. Ensure that there are no objects positioned within the measurement area. In the display 2, , , +" appears and the distance measured carries itself over to the lower line. The new measurement is added to the old measurement in the lower line. In the upper line the measured length appears and , , W" (Width) starts to flash. The measured width appears on the upper line and the result of the area calculation in the lower line. Both measurements are added together and the result is shown in the lower line. In the upper line the measured length appears and , , W" (Width) starts to flash. In the upper line the measured width appears and , , H" (Height) starts to flash. Both measurements are added together and the result is shown in the lower line. Before using the appliance for this task, first test it by locating a pipeline or electrical power cable at a known position. â· In cases of doubt, always ask a qualified building contractor. The locating of concealed objects is the same in all three modes (STUD = wood, AC WIRE = live electric power cables, METAL = metal). Place it flat against the wall where you wish to search for concealed objects. As the arrows in the display move closer to the centre of the display, you are getting closer to the concealed object. [. . . ] A battery symbol appears in the display 2 when the battery is weak resp. If you do not intend to use the appliance for an extended period, remove the battery from the battery compartment. Dispose of the appliance through an approved disposal centre or at your community waste facility. [. . . ]