User manual KODAK ZM2

[. . . ] CAUTION: A card can only be inserted one way; forcing it may cause damage. Inserting or removing a card while the camera is on may damage the video/pictures, the card, or the camera. 1 Turn off the camera. Metal contacts face up. Close the door properly Purchase accessories See page 2 www. kodak. com/go/Zm2accessories 5 www. kodak. com/go/Zm2support Setting up your camera Connecting the strap 6 www. kodak. com/go/easysharecenter Setting up your camera Turning on the camera Setting the date/time At the prompt, press OK. OK Change date/time later see page 11 www. kodak. com/go/Zm2support 7 2 Using your camera Taking videos and pictures Take videos Press the OK button to start/stop recording. [. . . ] Transfer videos/pictures to your computer, or use a MICROSD/SDHC Card to take more videos/pictures. Card is full. Transfer videos/pictures to your computer or use another card. Unrecognized file. Transfer videos/pictures to your computer. An error has occurred. Transfer videos/pictures to your computer, then format the card. 14 www. kodak. com/go/easysharecenter Getting help Problem Camera will not turn on. Solution Ensure that the battery is charged. (If it's wet inside, let it dry for 24 hours. ) Videos are choppy or jumpy when played on a computer. Use ARCSOFT MEDIAIMPRESSION SE for KODAK Software for video playback (see page 12). Go to www. arcsoft. com/support. Ensure that the lens is clean. Videos are blurry. Ensure that the subject is at least 1 m (3. 3 ft) from the lens. Problems with ARCSOFT Go to www. arcsoft. com/support. (For other applications, go to their support MEDIAIMPRESSION SE for sites. ) KODAK Software. NOTE: If problems persist, go to www. kodak. com/go/support and click Step-by-Step Solutions & Repair. www. kodak. com/go/Zm2support 15 Getting help Getting help on the Web Get support for your product www. kodak. com/go/Zm2support (FAQs, troubleshooting information, etc. ) See step-by-step solutions and www. kodak. com/go/stepbystep repair information Purchase camera accessories www. kodak. com/go/Zm2accessories Download the latest camera firmware and software www. kodak. com/go/Zm2downloads See online demonstrations of www. kodak. com/go/howto your camera Register your camera Chat, email, write, or phone Kodak (Chat not available in all languages. ) www. kodak. com/go/register www. kodak. com/go/contact Get information on ARCSOFT www. arcsoft. com/support Software 16 www. kodak. com/go/easysharecenter 4 Safety Appendix CAUTION: The use of an accessory that is not recommended by Kodak may cause fire, electric Use only a USB-certified computer equipped with a current-limiting motherboard. Contact your computer manufacturer if you have questions. Do not disassemble this product; there are no user-serviceable parts inside. KODAK AC Adapters and battery chargers are intended for indoor use only. The use of controls, adjustments, or procedures other than those specified herein may result in exposure to shock and/or electrical or mechanical hazards. For approved accessories, go to www. kodak. com/go/Zm2accessories. In the unlikely event that battery fluid leaks onto your skin, wash immediately with water and contact your local health provider. For additional health-related information, contact your local Kodak customer support. Go to www. kodak. com/go/reach for information about the presence of substances included on the candidate list according to article 59(1) of Regulation (EC) No. If using this product in an airplane, observe all instructions of the airline. For more information, go to www. kodak. com/go/batteries. Care and maintenance Before inserting or removing a card, make sure your hands, the camera, and the card are completely dry. If water has entered the camera, remove the card. Allow all components to air-dry for at least 24 hours before using the camera. a leak in water. Wipe off dirt or sand from the door seals--debris could compromise the seal and cause www. kodak. com/go/Zm2support 17 Appendix Do not subject the camera to temperatures lower than 0 (32° F) or higher than 40° C (104° F) for an extended time--the integrity of the seals may be compromised. Wipe gently with a soft, lint-free cloth or an untreated lens-cleaning tissue. Do not use cleaning solutions unless designed specifically for camera lenses. Do not allow chemicals, such as suntan lotion, to contact painted surfaces. For camera disposal or recycling information, contact your local authorities. [. . . ] In the event that the exclusion of any implied warranty is ineffective under the law, the duration of the implied warranty will be the length of the express warranty period specified on your KODAK Product packaging. The option of repair, replacement, or refund is Kodak's only obligation. Kodak will not be responsible for any special, consequential or incidental damages resulting from the sale, purchase, or use of this product regardless of the cause. Liability for any special, consequential or incidental damages (including but not limited to loss of revenue or profit, downtime costs, loss of the use of the equipment, cost of substitute equipment, facilities or services, or claims of your customers for such damages resulting from the purchase, use, or failure of the Product), regardless of cause or for breach of any written or implied warranty is expressly disclaimed. [. . . ]