User manual KODAK SC4

[. . . ] 4H7389 KODAK 4 Cell Smart Charger SC4 Operating Instructions EN CHARGE INDICATOR LIGHTS Red . . . . . . . . . . . . . . . . . . . . . . . . Place 2 or 4 AA, or 2 or 4 AAA size NiMH rechargeable batteries into the charger so that the + (positive) and ­ (negative) ends (terminals) of the batteries correspond to the same + and ­ markings in the charger. [. . . ] Do not operate charger if it has been subjected to electrical or physical shock or other damage. · For connection to a supply not in the U. S. A. , use an attachment plug adapter of the proper configuration for the power outlet. This battery charger is intended to be correctly oriented in a vertical or floor mount position. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. · Children should be supervised to ensure that they do not play with the appliance. · It is normal for batteries to become warm while charging. Regulatory Information FCC compliance and advisory This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) reorient or relocate the receiving antenna; (2) increase the separation between the equipment and the receiver; (3) connect the equipment to an outlet on a circuit di erent from that to which the receiver is connected; (4) consult the dealer or an experienced radio/TV technician for additional suggestions. [. . . ] (NOTE: Do not insert or remove batteries during this charging process. ) See Specifications for charging time. 100-240 V AC 50/60 Hz 4W Output (AA) DC 2. 8 V - 310 mA (AAA) DC 2. 8 V - 120 mA Battery/Approx. Charge Times AA mAh Time (hrs. ) AAA mAh Time (hrs. ) 2700 10. 1 1000 9. 7 2600 9. 9 900 8. 5 2500 9. 5 850 8 2100 7. 9 1800 6. 8 1700 6. 4 SUPPORT www. kodak. com/go/support www. kodak. com/go/contact Made in China for EASTMAN KODAK COMPANY Rochester, New York 14650 U. S. A. [. . . ]