User manual KODAK PLAYTOUCH ZI10

[. . . ] To zoom, tap (or tap and hold) the zoom control + (Telephoto) or - (Wide). Enhancing your experience Settings Choose a video resolution (or take pictures; see page 13). to Zoom control (Wide/Telephoto) Effects Apply an LCD Glare Shield filter (see page 15). NOTE: To apply a filter, the feature must be turned on in the Settings menu (see page 14). Adjust LCD brightness (see page 14). Plug in headphones or an external microphone, then tap Headphone or Microphone. www. kodak. com/go/easysharecenter 10 Reviewing videos/pictures Play Volume 1 Tap the Review icon . [. . . ] (Drag or swipe to find an email address. ) To mark other videos/pictures with the same address(es), scroll through them. When you transfer the video/picture to your computer (see page 12), it is sent to the email address that you chose. When finished, tap Save. www. kodak. com/go/playtouchsupport 19 2 Problem Getting help Solution Ensure that the battery is correctly inserted and Camera will not turn on. charged. Ensure the camera is clean and dry. (If it's wet inside, let it dry for 24 hours. ) LCD is not clear. Choose an LCD Glare Shield (see page 15). Can't transfer Do not use the USB cable. Long videos are split into separate videos. Use ARCSOFT MEDIAIMPRESSION for KODAK Software for video playback (see page 12). Go to www. arcsoft. com/support. Ensure that the computer system requirements When taking long videos, the camera begins a new video (at approximately 3. 8 GB) and continues recording. If desired, use video editing software on your computer to join videos. Videos are in If no card is inserted and the camera is powered by the AC adapter, then videos are taken in low low resolution resolution and are not saved. (The camera is in and/or are not Demo mode. ) Insert a card or unplug the AC saved. The use of controls, adjustments, or procedures other than those specified herein may result in exposure to shock and/or electrical or mechanical hazards. The use of an accessory that is not recommended by Kodak may cause fire, electric shock, or injury. For approved accessories, go to www. kodak. com/go/playtouchaccessories. Use only a USB-certified computer equipped with a current-limiting motherboard. If using this product in an airplane, observe all instructions of the airline. Follow all warnings and instructions supplied by the battery manufacturer. Use only batteries approved for this product to avoid risk of explosion. Otherwise, a battery may short circuit, discharge energy, become hot, or leak. Do not disassemble, install backward, or expose batteries to liquid, moisture, fire, or extreme temperature. In the unlikely event that battery fluid leaks inside the product, contact Kodak customer support. In the unlikely event that battery fluid leaks onto your skin, wash immediately with water and contact your local health provider. For additional health-related information, contact your local Kodak customer support. Go to www. kodak. com/go/reach for information about the presence of substances included on the candidate list according to article 59(1) of Regulation (EC) No. Care and maintenance Before inserting or removing the card/battery, make sure your hands, the camera, and the card/battery are completely dry. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. The KODAK High Performance USB AC Adapter K20-AM complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CE Hereby, Eastman Kodak Company declares that this KODAK Product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. [. . . ]