User manual KODAK ESP QUICK GUIDE

[. . . ] Networking Setup Guide Guide de configuration réseau Guía de configuración de red Guia de configuração de rede All-in-One Printers · Imprimantes tout-en-un Impresoras multifunción · Impressoras Multifuncionais 1 Choosing a Connection Type Make sure you completed the steps in the Start Here Guide. Then choose one of the following connection types for your printer, and see the corresponding chapter for instructions. · For additional networking information or troubleshooting, go to www. kodak. com/go/inkjetnetworking. Wireless (Wi-Fi) connection To connect your printer to a wireless network, see Setting Up the Wireless (Wi-Fi) Connection, page 2. Back Home Rotate MS SD/HC MMC Ethernet connection To connect your printer to a wired network using an Ethernet cable, see Setting Up the Ethernet Connection, page 4. 1 www. kodak. com/go/aiosupport 2 Setting Up the Wireless (Wi-Fi) Connection Before you connect You need to: · Have a functional 802. 11 wireless network. [. . . ] Record your network information in the spaces below, using the correct uppercase and lowercase letters. Network Name (SSID): __________________________________________________________________________ Security String: _________________________________________________________________________________ 1. NOTE: The Wi-Fi radio turns on automatically when you select WiFi Setup Wizard. The printer searches for available wireless networks within range, then displays the list in order of signal strength. If there are more networks than can be shown on the LCD, a (page down) symbol appears in the bottom right of the display. If you don't see your network in the list, or if you want to change your network, select Rescan for Wireless Networks, then press OK. www. kodak. com/go/aiosupport 2 Setting Up the Wireless (Wi-Fi) Connection 4. If the name of your network is: Listed Not Listed Press to select your network, then press OK. Make sure your wireless router is turned on and within range. Select WEP or WPA/WPA2 as required for your network's security setup, then press OK. 5. If your network has security enabled, use the LCD keyboard to enter your security string. If the printer is successfully connected, the Wi-Fi status light should be on. If you are unable to connect your printer, go to www. kodak. com/go/inkjetnetworking. When the printer is successfully connected, install the KODAK All-in-One Printer Software on your computer. Follow the on-screen instructions to complete your setup. Connecting to a WPS wireless router 1. NOTE: The Wi-Fi radio turns on automatically when you select Wi-Fi Setup Wizard. [. . . ] Connect the Ethernet cable into the Ethernet port on the back of the printer. 2. Connect the other end of the Ethernet cable into an available Ethernet port on your router, switch, or hub. Follow the on-screen instructions to complete your setup. www. kodak. com/go/aiosupport 4 Eastman Kodak Company Rochester, NY 14650 © Eastman Kodak Company, 2009 Kodak is a trademark of Eastman Kodak Company. [. . . ]