User manual KODAK ADVANTIX 3200AF

[. . . ] These limits provide reasonable protection against interference in residential use. The camera generates, uses and can radiate radio frequency energy and, if not used in accordance with the instructions, may cause interference to radio communications. [. . . ] Slide the film-door latch (16) and insert the film cassette completely into the film chamber . After you close the safety-interlock film door, you cannot open the film door until the film is completely rewound into the film cassette. 13 TAKING PICTURES You can take Classic (C), HDTV (H), and Panoramic (P) pictures on the same film cassette (see following table for Typical Print Sizes). Your photo-processing cost will be based on the format size(s) that you use to expose the film. Look through the viewfinder eyepiece (13) and place the aiming circle (d) on the subject. For a sharp picture, stand at least 21/2 ft (0. 8 m) from your subject. Press the shutter button (1), to take a picture. 14 Typical Print Sizes C Classic 3 1/2 x 5" or 4 x 6" (88. 9 x 127 mm or 102 x 152 mm) H Group & Wide (HDTV) 3 1/2 x 6" or 4 x 7" (88. 9 x 152 mm or 102 x 178 mm) P Panoramic 3 1/2 x 10" to 4 x 11 1/2" (88. 9 x 254 mm to 102 x 292. 7 mm) 15 Using the Self-Timer 1. Use a tripod (tripod socket [15]) or place the camera on another firm support. The self-timer lamp (3) will "blink" for 10 seconds before the picture is taken. NOTE: If you want to stop the self-timer operation before the picture is taken, press the self-timer button again or close the lens cover/flash. 16 Tips for Better Pictures · Hold the camera steady when taking pictures. Move close enough to your subject so it fills the viewfinder but not closer than 2 1/2 ft (0. 8 m). [. . . ] Once you've used this feature, you cannot reload the same film cassette into the camera. 20 TROUBLESHOOTING What happened Camera will not operate Probable cause There are no more pictures remaining Battery weak, dead, missing, or improperly inserted Solution Remove the film Replace or reload the battery Replace or reload the battery (see Solution above) (table continues on next page) 21 Film does not advance or rewind LCD panel is blank Battery weak, dead, missing, or improperly inserted (see Probable cause above) What happened Film rewinds at beginning of film load or middle of cassette (empty cassette symbol [21] "blinks" on LCD panel) Film does not insert completely into film chamber; film door does not close All LCD indicators "blink" Probable cause Camera transport or film cassette problem Solution Load another film cassette into camera Call Kodak for assistance Loaded exposed, partially exposed, or processed film into the camera Camera mechanism problem Load only unexposed film into the camera Press shutter button, close and open the lens cover/flash, or replace or reload battery 22 SPECIFICATIONS Film Type: KODAK ADVANTIX Film for color prints Lens: 25 mm, f/4. 6 KODAK EKTANAR Lens Focus System: 2 zones, active autofocus with zone crossover at 5 ft (1. 5 m) Viewfinder: Real image with C, H, and P format display Film-Speed Range: DXIX (ISO) 100, 200, 400 & 800 for color print films Flash Unit: KODAK SENSALITETM Flash Focus Range: Daylight: 2 1/2 ft. (0. 8 m) to infinity Apertures: f/4. 6, f/8. 8 Shutter: Programmed electronic; speeds 1/100 and 1/160 sec. [. . . ]