User manual KOCOM KC-C61

[. . . ] pipe using adiabatic substances, to prevent air circulation Stopping up pipe as above minimizes temperature difference between indoors and outdoors, and also eliminates moisture and condensation on door camera window. When visitor calls, the voice from monitor comes out of the speaker. Option notice Don't install the set on a weak or ceiling surface such as plaster or press board, please install the set on the hard wall or ceiling like firm timber or concrete. Video Doorphone Wiring Diagram Wiring Diagram Door camera Installation Surface-mounting Door Camera Installation DOOR CAMERA INSTALLATION Wall Screw(4x10mm) Upward control groove Straight Ahead Installation After attach the body supporter with 2 screws(4x10mm), put the Door Camera into the grooves of body supporter, and then fix it with a screw(2. 6x6mm). bady support Screw(2. 6x6mm) Upward support Camera Front (Option) Caution for wiring Wiring between videophone and camera is 4 wire in polarity and use 0. 65mm or more single cable Connecting wiring between monitor and door camera should not be installed near other electrical cable, norbe horizontal. (In such case, clear picture can not be expected due to interruption by electrical noise) Upward control groove Looking "Upward" Installation After attach the body supporter with 2 screws(4x10mm), insert the upward support into the upward groove of body supporter, and then fix it with a screw(2. 6x6mm). Standard Height of Door Camera Bottom base of One hall Box Surface mount Standard height of the door camera is 1, 400mm 1, 450mm from the bottom of one camera to the floor. 1, 250mm1, 550mm, it is impossible to control the screen picture with only the lens angle, and therefore, be careful of the height of camera installation. Monitor Installation When system is attached to 1 rectangular switch box Screw Wall Screw Flush mount Basic Installation method of Monitor Wall hanger panel for fixing Monitor 1 Rec tangular switch box Wall hanger panel for fixing Monitor Looking "Downward" Installation Downward control groove (unit:mm) Standard height monitor Standard height of monitor is ranged 1, 450 ~ 1, 500 from bottom to the center of monitor screen. For installation, avoid the places where there is any excessive humidity, magnetic force, dangerous chemicals, direct ray of sun, and any places near a heater which can cause break down. Center of monitor After attach the body supporter with 2 screws(4x10mm), insert the Door Camera into the downward control groove, and then fix it with a screw(2. 6x6mm). Bottom of 1Rectangular switch box (unit:mm) 10. Ventilation - Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered. [. . . ] Replacement Parts - When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. Safety Check - Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. Wall or Ceiling Mounting - The product should be mounted to a wall or ceiling only as recommended by the manufacturer. The exclarnation point with in a equilateral triangle, is intended to alert the user to the presence of important operating and maintenance(Servicing)instructions in the literature accompanying the appliance. Alternate Warnings - This product is equipped with a three-wire grounding-type plug, a plug having a third (grounding) pin. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Power-Cord Protection - Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. Protective Attachment Plug - The product is equipped with an attachment plug having overload protection. See Instruction Manual for replacement or resetting of protective device. If replacement of the plug is required, be sure the service technician has used a replacement plug specified by the manufacturer that has the same overload protection as the original plug. Outdoor Antenna Grounding - If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Lightning - For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. Overloading - Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. Object and Liquid Entry - Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Servicing - Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. [. . . ] Phone number and address at which you can be contacted. KIV-101 03. 04 HANDS-FREE VIDEOPHONE 4Flat Monitor 4 Wired Easy Installation Slim Size Camera Wide view angle KC-C61 (120 ) KC-D30 (90 ) Hands-free System Clear & Bright Picture at Low Light KIV-101 KIV-101 Operating Installation Manual KC-C61 Thank you very much for purchasing KOCOM video doorphone. please read this manual thoroughly to ensure correct usage, before operating Metal Pinhole Camera KC-D30 www. kocom. co. kr e-mail:export@kocom. co. kr www. kocominc. com(us) e-mail:sales@kocominc. com(us) Option 3. While you communicate with the visitor through camera, if the call from guardroom is made, the melody sound is ringing. And you can communicate with guardroom by pressing guardroom or communication button after finishing the communication with visitor. 2. While you communicate with guardroom, if the chime sound from the camera is made the screen is on, then you can check the visitor. (The screen is on for 30 seconds and automatically off) At this time, if you press camera or communication button, the communication with guardroom is ended and you can communicate with the visitor through the camera. 1. [. . . ]