User manual KLIPSCH SW-450

[. . . ] The mains plug of the power supply cord shall remain readily operable. the exclamation point , within an equilateral triangle , is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electrical shock to persons. WARNING: To reduce the risk of fire or electrical shock, do not expose this apparatus to rain or moisture. [. . . ] Connect the BLACK "negative" (-) terminal of your amplifier's LEFT channel to the BLACK "negative" (-) terminal of your subwoofer's LEFT channel input ("SPEAKER Level IN"). Repeat this procedure for connecting your amplifier's RIGHT channel to your subwoofer's Take care to ensure that no bare wires from any of the connections touch any other terminals, as this could cause a short and damage your equipment. Frequencies above the control setting are filtered out, allowing you to blend the subwoofer's output with that of your main speakers. For sources with an LFE output or that use an internal crossover, the lowpass filter should be defeated by setting the control to "BYPASS". "VOLUME" ­ This control serves as an overall volume control for the subwoofer. It is used to match the output level of the subwoofer to the main speakers. "PHASE" 0/180 ­ This control is used to acoustically match the subwoofer's output to your main speakers. Select the position either 0° or 180° in which your subwoofer has more output at the listening position. Off/Auto/On ­ When this switch is in the "ON" position, the subwoofer will remain on at all times. When this switch is in the "AUTO" position, the subwoofer will automatically turn "on" when it senses a signal. It will automatically go into "standby mode" after 15-20 minutes with no signal. When this switch is in the "OFF" position, the subwoofer will remain "off" until the switch is manually turned back to the "ON" or "AUTO" position. LED indicator­ Klipsch SW subwoofers have an LED indicator on the front that indicates the status of the built in amplifier. The LED will light blue when the amplifier is on and receiving a signal. When the unit is in standby mode or turned off, the LED indicator will turn off. Your subwoofer has a durable vinyl finish that should only require dry dusting or cleaning with a dry cloth. avoid the use of abrasive or solvent-based cleaners and harsh detergents. The brush attachment of your vacuum should remove any dust from your subwoofer enclosure. Klipsch will keep you up-to-date on new products and promotions · Your personal information will never be resold Register your product online at www. The Warranty below is valid only for sales to consumers in the United States or Canada. ("KLIPSCH") warrants this product to be free from defects in materials and workmanship (subject to the terms set forth below) for a period of five (5) years from the date of purchase. During the Warranty period, KLIPSCH will repair or replace (at KLIPSCH's option) this product or any defective parts (excluding electronics and amplifiers). [. . . ] Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Caution: Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this device. Note: This mark applies only to countries within the European Union (EU) and Norway. This application is labeled in accordance with European Directive 2002/96/EC concerning waste electrical and electronic equipment (WEEE). [. . . ]