User manual KLIPSCH RVX

[. . . ] Center-Channel Speaker: Center the speaker directly above or below your video screen. The integral stand allows the speaker to be placed on top of the TV (or on a shelf just above or below it) or mounted on the wall (see wall mounting instructions). Ideally, the speaker's front baffle should be flush with the front of the screen. Front Left and Right Speakers: The front left and right speakers should be approximately in line with your video screen and equidistant from it. [. . . ] BUT FIRST: TYPES OF CONNECTORS Bare wire -- Pull the two conductors apart for about an inch and strip approximately 1/4" of insulation from the end of each. (A wire stripper will simplify this, but you can use an ordinary pocket knife to cut around and through the insulation down to the wire. ) Twist the strands of wire on each individual conductor tightly together. Loosen the nuts on a pair of binding posts until the holes through the metal posts are exposed, then insert the bare wire through the holes. Make sure that no strands of wire are touching from one binding post to the other or to any strands from the other conductor. Failure to observe this precaution at either end of the connection can result in amplifier malfunction or damage. Loosen the nuts on a pair of binding posts until the holes through the metal posts are exposed, then insert the pins through the holes. Make sure that there is no metal-to-metal contact between the two pins or binding posts. Failure to observe this precaution at either end of the connection can result in amplifier malfunction or damage. Spade lugs -- Some speaker cables are terminated with U-shaped connectors called spade lugs. Loosen the nuts on a pair of binding posts and slip the spade lugs around the metal posts. Screw the nuts down finger-tight on the lugs and inspect to ensure they have remained firmly in place. Make sure that there is no metal-to-metal contact between the two lugs or binding posts. Failure to observe this precaution at either end of the connection can result in amplifier malfunction or damage. Figure 2 You may also use an optional wall or ceiling mount that will fit the provided 3/8" ­ 16 inserts. Please see your authorized Klipsch dealer to determine which model is right for you. One of the most important things about hooking up your speakers is keeping them in the same polarity, or phase. If they are connected out of phase, bass and sound localization will be degraded. The easiest way to ensure that your speakers are wired in phase is to always connect the positive and negative output terminals on your amplifier or receiver to the matching input To install the RVX-42, follow the instructions below: terminals on your speakers: positive ("+", color-coded red) to positive and negative ("­", color1. Locate the included wall mount template with bubble level and position on the wall in the desired location. Screw #8 pan head wood screws (at least two inches in length) into a wood stud or dry wall anchors with the appropriate load rating. Leave the screw heads protruding from the wall surface approximately 1/4" and adjust as needed when hanging the speaker. [. . . ] During the Warranty period, KLIPSCH will repair or replace (at KLIPSCH's option) this product or any defective parts (excluding electronics and amplifiers). For products that have electronics or amplifiers, the Warranty on those parts is for a period of two (2) years from the date of purchase. To obtain Warranty service, please contact the KLIPSCH authorized dealer from which you purchased this product. for multiple speaker purchases , please fill out only one warranty card. [. . . ]