User manual KLIPSCH RT-10D

[. . . ] DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. [. . . ] ⷠThe display will return to the "Volume" screen if no keypad inputs are made 10 for seconds. The second button press will initiate a control adjustment or the selection of another mode. ⷠIn periods of low humidity, it is possible that a static electricity discharge to the subwoofer may cause a momentary interruption in the subwoofers output or changes to the LCD display content. Any display content errors will be corrected when the screen changes modes. "Volume" ­ Use the Left/Right cursor keys to adjust the subwoofer's volume level to match the output of your main speakers. From this screen press the down cursor key to access other control settings. "Recall Settings:" ­ This screen is used to select any one of five user defined memory presets titled "Movie", "Music", "Night" "User 1" and "User 2". Use the Left/Right cursor keys to select the desired group of stored control settings and press the Enter key " " to apply them. During initial setup, skip this screen until all other initial control adjustments have been made. If nothing has been saved "Phase" - This screen is used to adjust the subwoofer's acoustic phase to match that of your main speakers. Use the Left/Right cursor keys to adjust the subwoofer's phase from 0° to 180°. The proper setting of this control is highly dependant on room acoustics and the position of your subwoofer in the room. After setting the volume and low pass controls, adjust the phase to 0° and listen to a recording with a prominent, repeating bass line in your intended listening position. Repeat this process with the 180° setting and use the setting that yields the greatest amount of bass output. If neither of these settings is better than the other experiment with intermediate settings. From this screen press the down or up cursor key to access other control settings. "Room Correction" ­ This screen is used to activate the automatic room correction feature. Plug the supplied microphone into the ("MIC IN") jack on the subwoofer's rear panel and place it in the intended listening position. Press the Enter button to activate the test sequence, "Calibrate" will be displayed along with the ascending frequency of the test tone and a bar graph of the sound level (loudness). the subwoofer will measure the room's acoustic effect and compensate for it. When the calibration sequence is complete "Calibration Successful!If the subwoofer's volume level is too low or the microphone was either disconnected or improperly connected "Calibration Unsuccessful" will be displayed. [. . . ] CARE AND CLEANING OF YOUR POWERED SUBWOOFER Your subwoofer has a sealed, wood veneer finish that should only require dry dusting or cleaning with a dry cloth. avoid the use of abrasive or solvent-based cleaners and harsh detergents. The brush attachment of your vacuum should remove any dust from your subwoofer enclosure and grille. AND CANADA ONLY The Warranty below is valid only for sales to consumers in the United States or Canada. [. . . ]