User manual KLIPSCH IFI

[. . . ] DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. DO NOT defeat the safety purpose of the polarized or grounding type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. [. . . ] This input is mixed with the signal from the dock, whether from the iPod or from the auxiliary input so that both sources are heard simultaneously. This allows for, as an example, the sound from your computer to be heard while music is playing from an iPod in the dock. Subwoofer and Speaker Placement Although you can place the components of the iFi system almost any way that is convenient, speaker location will affect sound quality. The subwoofer will generally perform best when placed on the floor in a corner. The farther it is moved toward the middle of the room, the lower the bass output will be. You will get the best stereo effect with the satellite speakers placed equidistant from the listening position. If possible, avoid locating either satellite closer than two feet from a side wall. If that is not practical, adjust the stands' ball joints to aim the satellites up or down toward the listening position. Stand Adjustment and Wall Mounting The speakers attach to their stands via a ball joint that allows them to be swiveled over a wide range. To adjust the angle, un-snap the supplied hex wrench from underneath the base, loosen the four screws in the clamp plate that surrounds the ball joint. Each stand also incorporates an adjustable down stop to prevent the speaker from drooping after its angle is adjusted. You can access the head of this down stop from the bottom side of the stand. RF Remote Control Your radio-frequency (RF) remote control comes with its battery installed. If you find the remote control is conflicting with another nearby iFi system, see the "Remote Control" section for instructions on synching the dock with the remote control. SYSTEM OPERATION To adjust the subwoofer level, first push the Volume/Subwoofer Select button, then turn the Volume knob. Pressing the Volume/ Subwoofer Select button again will switch the knob back to master volume control. NOTE: When in the Subwoofer mode, the system will automatically revert to master volume after five seconds. Light Bar The light bar on the control dock indicates current master volume or subwoofer level, depending on the setting of the Volume/Subwoofer Select button. When subwoofer level is being adjusted, the light bar will indicate the relative subwoofer level as shown below. Power The Main Power switch on the rear of the iFi subwoofer must be On for the system to operate. You can switch the system between Standby and On modes from the control dock or with the remote control. The Power LED on the control dock will glow amber in Standby mode and green when the system is On. No light indicates that the Master Power switch on the subwoofer is turned Off or that the power cord is unplugged. Holding the Skip FWD or Skip REV button down for a few seconds will fast-forward or rewind the current track. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages or implied warranties so the above exclusions may not apply to every customer. This warranty gives you specific legal rights, and you may have other rights which vary from State to State. If you purchased this product from a retail store, please return this product to such store in its original packaging along with proof of purchase. If you purchased this product from a computer manufacturer, please contact that manufacturer. [. . . ]