User manual KITY MACHINE A BOIS

[. . . ] • Make sure that the air inlet behind the fan grille is never obstructed. The built-in hob should, in fact, be provided with suitable ventilation for the cooling of the electronic components used in the appliance. • We advise against the installation of an induction hob above an under-the-counter refrigerator (heat) or above a washing machine (vibrations). In fact, there would be insufficient space for the ventilation of electronic components. [. . . ] We recommend you wipe these off before using the appliance, with the aid of a non abrasive cleaner. During the first few hours of use, you may detect a smell of rubber, which will disappear quickly. 26 Installation and fastening The following instructions are intended for a qualified fitter to guide him/her along the installation, adjustment and technical maintenance procedures as correctly as possible and in full compliance with the applicable norms in force. Installation • This hob can be built into a worktop simply by cutting out the corresponding slot. € The worktop must be made with a material designed to withstand a temperature of approximately 100°C. € The hob should be positioned at least 40 mm away from the back wall or any other vertical surface in order to allow for correct ventilation and to prevent the surfaces around the appliance from overheating. € If you wish to install the hob on top of an oven, the latter must be fitted with a cooling fan. € Try to avoid installing the hob on top of a dishwasher; if this is unavoidable, place a watertight separating element between the two appliances. Fastening Very important: It is vital that you ensure the glass ceramic hob is built into a perfectly flat supporting surface. Deformations due to improper fastening could alter the characteristics of the hob and compromise its performance. Insert the hob into the cut-out slot, applying pressure all along the perimeter of the hob frame so that the latter adheres fully to the worktop. Lock indicator light 1 11 12 Note • The timer control key (7), the cooking time indicator (8) and the zone indicator light (9) are only fitted on hobs featuring one or more timers (KBT 8424 IDO 400 - KBT 8424 IDO - KOT 7424 IO 400 - KOT 7424 IO - KBT 6114 ID - KBT 6124 ID 400 - KBT 6124 ID - KBT 6323 IO - MACHINE A BOIS). € The booster key (10) is only fitted on hobs featuring a booster (KBT 8424 IDO 400 - KBT 8424 IDO - KOT 7424 IO 400 - KOT 7424 IO - KBT 6114 ID - KBT 6323 IO - KBT 6124 ID 400 - KBT 6124 ID - KBT 6013 ID - MACHINE A BOIS). 30 Operation When you connect the hob to the power supply, a beep will sound after a few seconds: you can now turn the hob on. Controls lock When the hob is in use, you can lock the controls to avoid any accidental changes to the settings (by children or when cleaning, for example). Just press the key, the indicator light next to the key lights up and the controls are locked. To change the power level setting or stop cooking, the controls have to be unlocked: press the key, the indicator light turns off and the controls are unlocked. € or press the “-” key: the heating power drops progressively until the zone eventually turns off. If you have locked the hob controls (see paragraph below), the same will still be locked when you turn the hob back on. The booster The booster is only fitted on hobs KBT8424 IDO 400 KBT8424 IDO - KOT7424 IO 400 - KOT7424 IO - KBT6114 ID - KBT6323 IO - KBT 6013 ID - KBT 6124 ID 400 - KBT 6124 ID - MACHINE A BOIS. To speed up the rise in temperature of the cooking zones (see cooking zone table on the previous page), press the key. When the booster function is on, certain cooking zones (see the cooking zone table on the previous page) are limited to a maximum power of 600W. [. . . ] € Never leave aluminium wrappers, aluminium foil and plastic cookware on the hob when hot or still warm. € Do not use steam cleaners or high pressure cleaners to clean your appliance. € Do not place metal items on the hob (such as knives, spoons, lids, etc. The guarantee does not cover damage to the hob caused by incorrect use. [. . . ]