User manual KISS COOLVIEW

[. . . ] KiSS Coolview u s e r 's m a n u a l Thank you for selecting our KiSS Coolview monitor. Please take a few minutes to read this user's manual for the best performance of this TV. The present home appliance is certified and approved by EMC/EMI and can be used in all places including residency area. Information in this manual is subject to change without prior notice. Ver1. 00E FCC Information This equipment has been tested and found to comply with limits for a class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Memorizing TV Channels To search TV channel, press SCAN button in TV mode. To stop searching TV channel and to store searched TV channel, press MENU button. When the power is cut off or the unit system is reinitialized, all the recorded channel information disappears. To erase searched TV channel, use channel edit function of menu mode Channels 2~69 are for "off-air"(antenna) and channels 1 and 14~125 are for cable channels. You can choose the desired value of selected menu by turning the button. 2. MENU : Menu selection You use the button to start or quit the menu mode. You can enter sub-menu or return to main-menu section by this button. 4. SOURCE : Selection among TV, PC monitor and other external inputs (Composite, SVideo) By pressing the button, you can have Analog RGB A Composite TV A Composite Video A S-Video A Analog RGB signal in turn. 19 TV MENU Picture 1) Brightness This controls the brightness of the LCD. Fill aspect ratio : Image displayed with an aspect ratio 4:3 Wide : lmage displayed with an aspect ratio 4:3 depending on the horizontal size 20 Advanced 1) Sharpness This adjusts the clarity and the focus of screen image. SHARP 1 A 2 A 3 A 4 A 5 SOFT 2) Gamma Linear : It shows gamma pattern of LCD TV type. Warm 5000 A 7300 A 9300 Cool USER : User can adjust each of R, G, B. Options 21 1) OSD It provides nine preset OSD positions. Opaque (gray), translucent (transparent) Utilities 1) Language User can select OSD language. 4) Auto adjust This adjusts the screen automatically to the best condition. You can do this by pressing the VOL button of remote control or by turning the OSD POWER button to the right. 22 5) Source You can select a source PC A TV A Composite A S-Video 6) Factory reset This allows you to reset all the OSD control settings back to the factory setting For this, either press the VOL button of remote control or turn the OSD POWER button to the right. TV 1) Source It selects a TV broadcasting signal (antenna/cable). 4) Fine tuning When you chose manual tuning mode, fine tuning function works. You can edit channels either by pressing VOL button on the remote control or turning POWER button to the right. 23 6) Channel search This searches and stores channels as remote control (SCAN button function). To search for channels, either press the VOL button on the right side of the remote control or turn the rotary button to the right. To stop channel search, press the MENU button on the remote control or on the function button. Channels 2~69 are for "off-air"(antenna) and channels 1 and 125 are for cable channels. You can do this by either pressing the VOL button on the right side of the remote control or by turning the rotary button of function button to the right. After the Channel swap window appears on the screen, you can change the current channel number to a new one you want. You can select new channel numbers to store by pressing the right VOL button on the remote control. [. . . ] Screen with lines or unstable image Check if there is an appliance in use disturbing electric waves (radiophone, hair drier, electric drill, etc. ). Unable to receive certain channels Check if the channel is set correctly. PC Monitor Troubleshooting No image on the screen The VGA cable should be connected completely to the TV and computer. Make sure that a supported mode has been selected on the display card or system in use. [. . . ]