User manual KIDDY RELAX PRO

[. . . ] Making any modifications to the child restraint system is not permitted. if difficulties arise , please consult your dealer or the manufacturer. The belt system and belt clip in particular must be checked regularly for wear and tear or possible damage. Always install your kiddy seat facing the direction opposite to the one in which you are travelling. [. . . ] Always keep the manual in the storage compartment underneath the baby car seat (A)!To adjust the carry handle (F), press both carry handle buttons (H) (Fig. Make sure that both carry handle buttons (H) are locked in place again!The carry handle (F) of your kiddy relax pro can be used in several different positions (Fig. 2 3 4 5 carry position installation position in vehicle with 3-point seatbelt feeding position (more upright) rocking position (for sleeping) 2 Unfolding and attaching the sunshield To fold back the sunshield, pull it forward in the direction of the foot-end of the baby car seat (Fig. Before you can adjust the headrest (E) or the height of the shoulder belts (D), the belt system must be slackened. Now the headrest (E) or the shoulder belts (D) can be adjusted to the size of the child or the child can be lifted out of the baby car seat. The belt system is connected to the headrest (E), which means the belt system must not be adjusted separately from the headrest (E)!The headrest (E) must be adjusted in such a way that the shoulder belts are positioned at the same level as the baby's shoulders (Fig. Let the height adjustment handle (M) click into place again after the headrest (E) has been adjusted. Make a point off always buckling up your child when it lies in the baby car seat (A)!Now pull the centre belt (J) until the belt system fits the body of the child snugly (Fig. Place the safety belt lock tongues (C) attached to the shoulder belts over each other (Fig. Place your baby in the baby car seat and then position the shoulder belts (D) over its shoulders (Fig. Make sure that the belt system is not twisted and does not fit the child's body too tightly. 1 Installation with the vehicle restraint Read up all the necessary information about the use of child restraint systems in your vehicle owner's manual. The kiddy relax pro child restraint system can be installed on any seat of vehicles equipped with a 3-point belt system (Fig. * The passenger airbag must be deactivated or another seat must be used. 2 Installation steps with the vehicle restraint Place your kiddy facing the rear on a seat without an active front airbag and with a 3-point belt (Fig. Pull the vehicle restraint out and feed the lap belt through both lap belt guides (I) and press the safety belt lock tongue with a clearly audible click into the belt clip (Fig. Now place the shoulder belt around the baby car seat (A) and feed it through the diagonal belt guide (L) at the rear of the kiddy seat (Fig. Swivel the carry handle (F) to the rear against the vehicle backrest and make certain that the carry handle buttons (H) lock into place (Fig. [. . . ] After an accident with an impact speed greater than 10 km/h, the child restraint system must be sent back to the manufacturer without fail, to be checked for possible damages and replaced at no charge if deemed necessary. The warranty covers child restraint systems that have been handled properly and are returned in a clean and orderly condition. For the kiddy relax pro pro we extend a warranty against defects in materials and workmanship for up to two years. Fabrics: All of our fabrics meet the highest standards regarding colourfastness against UV radiation. [. . . ]