User manual KIDDY NEST

[. . . ] Make sure that no parts of the kiddy nest or the straps get caught in doors or adjustable seats. Set adjustable backrests so that they come into contact with the holder of the baby car seat. Regularly check the parts of the kiddy nest, above all the strap system, for any signs of wear or other damage. Make sure, above all with vans, that the kiddy nest is used in an easily accessible place so that it can be reached in cases of emergencies. [. . . ] ) When removing the sunroof, tilt the holder towards the child's feet and push the fastening pins at the end of the frame out of the (fastening) holes. Loosen the cover on the kiddy nest to make it easier to find the fastening holes on the sides. Remove the strap system by pulling the strap ends through their respective openings on the cover. When you put the cover back on, please make sure that the straps are not twisted in the fabric when you thread them back through the openings. The kiddy nest is not suited for seats that are only equipped with a 2-point seatbelt for your waist. Please use the kiddy nest only on seats that have a 3 - point seatbelt. We recommend using the kiddy nest on the back seat of cars and on the easiest seat to reach in cases of emergencies in vans. Please use the operating handbook in your vehicle to inform yourself about the basics concerning children's seats in vehicles! Some car manufacturers however offer to shut off the front airbag in the manufacturer's workshop. The kiddy nest is not suited for seats that are equipped with active front airbags. After you have consulted the operating handbook for the vehicle, you can install the kiddy nest on the appropriate seat (see 4. - Make sure that the kiddy nest faces backwards on the car seat (please observe the instructions in section 4. Let the tongue plate snap in the belt lock with a clearly audible "click". Now slide the shoulder belt of the vehicle's own 3-point seatbelt around the back of the kiddy nest's headrest. This deactivates the automatic unrolling of the vehicle's own seatbelt system, so that the kiddy nest seat can be firmly installed. Securing your baby in the kiddy nest The kiddy nest has integrated shoulder straps with 3 different settings for the height so that your growing baby is always held in an ideal position in the kiddy nest. Please set the straps in accordance with the following illustrations: 5. Tighten the vehicle's own 3 - point seatbelt by pulling hard on the positions showed in fig. O adjust the shoulder straps, pull them from the back of the kiddy nest through the shoulder pads, the cover and through the baby seat. Please make sure that the straps are never twisted and that both shoulder straps are threaded through the baby's seat at the same height. The straps on the kiddy nest are to be used as follows: Please make sure that your baby is always buckled into the kiddy nest. After you have made sure that the shoulder straps are set to the right height (see 5. [. . . ] The plastic baby seat and the holder can be cleaned with a moist towel. The kiddy nest must be replaced or checked after an accident (at a speed of more than 10 km/h). We provide a 2 year guarantee for manufacturing or material defects on this baby car seat. The guarantee is limited to children's car seats that were handled appropriately and were returned in a clean and orderly state. [. . . ]